Overview
The Hi-Lift Jack SWR68S is a 68 inch Slide-n-Lock tie-down system built to secure heavy payloads. Its tie points slide along the rail and lock into self-locating holes spaced every 5 inches. It is universal fit, so it is not built for one vehicle.
Moving a tie point takes seconds: pull the spring-loaded locking pin, slide the point to the hole you want and let the pin seat. The rugged construction suits heavy loads.
Key features
- Self-locating holes every 5 inches
- Spring-loaded locking pin for quick repositioning
- Rugged construction for heavy loads
- Mounts with 1/4 inch diameter bolts in predrilled holes
- 68 inch length sliding tie down point
Heavy loads and tie point spacing
Heavy payloads put the most strain on the anchor points and the mounting surface, so the rail is only as strong as the surface it is bolted to. Before loading, check that the mounting area is structural and free of cracks or soft spots. Position tie points so straps pull toward the anchor rather than sideways, which keeps the load steady and reduces stress on the locking pins.
Re-check the fasteners after the first few loaded trips, since vibration can loosen them. Inspect the locking pins for wear, bending or sluggish spring action, and replace any pin that no longer seats fully. Keep the rail clean and free of mud so you can see whether each pin is seated correctly before you drive.
- Confirm the mounting surface is structural
- Re-tighten after the first loaded trips
- Replace worn or bent locking pins
Specifications
| Brand | Hi-Lift Jack |
|---|---|
| Part number | SWR68S |
| UPC | 70000350389 |
| Type | Sliding tie down point |
| Length | 68 inches |
| Hole spacing | Every 5 inches |
| Mounting bolt diameter | 1/4 inch |
| Bolt spacing | Approximately every 10 inches, in predrilled holes |
Vehicle fitment
Universal fit, so no specific vehicle is named. Check the 68 inch length and the bolt layout against your mounting surface before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation uses 1/4 inch diameter bolts placed approximately every 10 inches in predrilled holes. Confirm your mounting surface can accept that bolt pattern before starting.








