Overview
The G2 Axle and Gear 35-2090 is a master ring and pinion installation kit for GM 12 Bolt axles measuring 9.5 inches. G2 packages the install hardware and bearings for a rear ring and pinion in one kit, so the ring gear and pinion can be set up without sourcing each part separately.
This kit is matched by axle type rather than by vehicle. It is built for the GM 12 Bolt 9.5 Inch rear axle, and no model or year range is given.
Key features
- Master kit with bearings for a rear ring and pinion install
- Ring gear bolts and shims for mounting the ring gear
- Crush sleeve or spacer and replacement pinion nut
- Pinion seal and gasket or RTV silicone
- Timken tapered roller bearings included where applicable
Matching the 12 Bolt housing
A GM 12 Bolt axle is common on rear ends, and the housing size is the main check before buying a master kit. Measure the housing and compare it with the kit’s axle type. Inspect the carrier bearing bores and the pinion bore for wear, since damage there can affect pinion depth and carrier preload.
Setting a 12 Bolt ring and pinion involves pinion depth, carrier preload and backlash checks, followed by tooth contact with gear marking compound. Shim changes are made in small steps. Keeping notes and marking the carrier caps helps the setup repeat correctly if the carrier is removed later, and it makes the final check easier to trust.
- Confirm the housing is a 12 Bolt
- Inspect bearing bores for scoring
- Plan a separate gear set and matching bolts
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2090 |
| UPC | 631410136258 |
| Kit type | Master kit with bearings |
| Axle location | Rear |
| Axle type | GM 12 Bolt 9.5 Inches |
| Axle manufacturer | GM |
Vehicle fitment
The kit is matched to a GM 12 Bolt axle housing measuring 9.5 inches. Check the housing against that size and confirm the year, model and trim of your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting up a ring and pinion involves gear marking, pinion depth and backlash checks, so a professional gear setup is the usual route. Gear sets also need a proper break-in after installation.
What’s included
Ring gear bolts, shims, a crush sleeve or spacer, a pinion seal, a pinion nut, a gasket or RTV silicone, and Timken tapered roller bearings where applicable.
Not included: The ring gear and pinion gear set are separate parts and are not part of this kit.










