Overview
The G2 Axle and Gear 35-2031 is a master ring and pinion installation kit for the Dana 30 TJ front axle.
Jeep owners with a Dana 30 front axle that uses a short pinion will want to read the title closely: the 35-2031 carries the TJ label for that housing style. The box holds Timken pinion and carrier bearings with races, shims, a crush sleeve, nut, seal, ring gear bolts, and sealing and marking compounds.
This is the master kit for short pinion Dana 30 housings, the version used in TJ axles and separate from the standard Dana 30 kit. It brings together Timken bearings and races, shims, a crush sleeve, a pinion seal, ring gear bolts and the sealing and marking compounds in one purchase for the installer. Confirm the pinion type on your axle before ordering.
Key features
- Master installation kit for the Dana 30 TJ axle (front)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Before you start the install
Installing a master kit in a short pinion Dana 30 is a precision job. Pinion depth shims set where the pinion head sits against the ring gear, and the marking compound pattern is the only dependable check that the setup is right. Work in small steps and write down each shim change so you can return to a known starting point.
Many installers replace the carrier bearings and pinion bearings together with the gears, because the old parts wore under the same load. Reusing a worn bearing under fresh gears can bring back noise and early wear. Clean the housing face and check the bearing bores for scoring before pressing in new races.
- Clean old sealer from the housing face before fitting new gaskets
- Inspect the carrier for cracks before reusing it
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2031 |
| UPC | 631410095791 |
| Kit type | Master kit with bearings |
| Axle location | Front |
| Axle type | Dana 30 TJ |
| Axle manufacturer | Dana |
Vehicle fitment
It fits front Dana 30 short pinion axles. Confirm that your Dana 30 is the short pinion type before ordering.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
A short pinion Dana 30 has little room around the pinion head, so measure depth carefully and set the crush sleeve slowly. Finish by running the marking compound to check the pattern.
Before opening the Dana 30 TJ housing for the 35-2031 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2031 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2031 supplies installation parts for the Dana 30 TJ axle only.























