Overview
The G2 Axle and Gear 25-2036 is a Dana 70 HD minor ring and pinion installation kit for the rear axle. G2 builds this kit for the installer who is working on a newer vehicle and has no reason to replace the bearings during a gear change.
Inside the 25-2036 are the hard-to-find extras that complete a differential setup: a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. The part is a heavy-duty variant listing for Dana 70 rear axles, and it is separate from the standard Dana 70 kit.
Key features
- Dana 70 HD rear axle minor installation kit
- Meant for jobs where the bearings are reused
- Includes the shim kit needed to set the gear mesh
- Replacement pinion nut and crush sleeve supplied
- New pinion seal and ring gear bolts
- Silicone sealer, Loctite and marking compound round out the set
Heavy-duty axle considerations
A heavy-duty Dana 70 HD is built to handle more torque, so the gear mesh and carrier fit need to be right from the start. Plan on a careful layout check before final assembly, and expect the setup to take longer than on a lighter axle. Clean all mating surfaces before the cover and carrier go in.
Because the crush sleeve sets preload once, tighten the pinion nut in steps while the rotating drag is measured. Marking compound and a dial indicator help confirm depth and backlash. Recheck fasteners after the first drives, and inspect the pinion seal for seepage, since heavy-duty use can expose small leaks.
- Clean mating surfaces before reassembly
- Measure rotating drag at each preload step
- Recheck bolts after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2036 |
| UPC | 631410095098 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Dana |
| Axle type | Dana 70 HD |
| Axle location | Rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
The kit is matched to the Dana 70 HD rear axle, not to a named truck or year range. Vehicle year, model and trim should be checked before buying.
This kit does not cover front axles or Dana 60 and Dana 80 differentials, and the standard Dana 70 kit has a different part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear marking compound is used after the shims are set to read the contact pattern, and the crush sleeve is a one-time part that sets pinion preload. Because the 25-2036 holds no gear set, plan on a professional setup for the Dana 70 HD.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: gears, bearings and a carrier.







