Overview
The G2 Axle and Gear 25-2044 is a Toyota Land Cruiser 9.5 Inch minor ring and pinion installation kit for the front or rear axle. It is meant for a gear swap on that large Toyota differential when the bearings are being kept.
The kit holds the small parts an installer needs and a parts store seldom stocks: a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. The parts are matched to the Toyota 9.5 inch axle.
Key features
- Land Cruiser 9.5 Inch axle installation kit
- Front or rear axle location
- Proper shim kit for gear setup
- Replacement pinion nut, crush sleeve and pinion seal
- Ring gear bolts, silicone sealer and Loctite
- Gear marking compound for pattern checks
Before you buy
A ring and pinion swap changes the gear mesh inside the differential, so the kit is only one part of the job. Before ordering, identify the axle size under the vehicle and confirm it is the 9.5 inch Toyota axle. Confirm the axle size and your vehicle’s year, model and trim before ordering.
Gear sets are sold separately from this kit, so plan for them as well. Worn or chipped gears should be replaced together with a matching pinion, and any bearings that show roughness or play are better handled as a separate purchase before the install begins. Setting up the mesh and preload takes patience, and many installers check the pattern more than once before the housing is closed.
- Measure the axle size before choosing a kit
- Plan for a new gear set and any bearing work
- Keep a clean bench and labeled parts during teardown
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2044 |
| UPC | 631410095135 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Toyota |
| Axle type | Toyota 9.5 Inches |
| Axle location | Front or rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
The 25-2044 is a Universal Fit kit for the Toyota Land Cruiser 9.5 Inch axle. Match your Land Cruiser’s axle size before choosing it.
The 25-2044 does not cover the smaller Toyota axles, and no Land Cruiser years are stated. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the 25-2044 uses shims and a crush sleeve, the gear mesh and pinion preload must be set carefully, and gear marking compound shows the result. A trained installer is the normal route for a Land Cruiser differential. Loctite goes on the ring gear bolts to keep them from backing out, and the silicone sealer is used where the housing is closed back up.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: the ring and pinion set and bearings.







