Overview
The G2 Axle and Gear 35-2096 is a master ring and pinion installation kit for the GM 9.25 Inches IFS front axle.
The 35-2096 is the early-version master kit for the GM 9.25 inch IFS front differential. It contains Timken pinion bearings and races, carrier bearings and races, shim packs, a crush sleeve, a nut and seal, ring gear bolts, and the sealer and compounds.
This early-version kit is limited by G2 to 1988-2010 IFS front axles, the GM 9.25 inch type. It brings the Timken pinion bearings with races, carrier bearings with races, shim packs, crush sleeve, pinion nut and seal, ring gear bolts, thread locker, marking compound and silicone sealer, so the front differential can be reassembled with all of its wear parts replaced.
Key features
- Master installation kit for the GM 9.25 Inches IFS axle (front)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Checking the front differential
The GM 9.25 inch IFS front differential is the axle type this early-version kit covers, and the kit supplies the wear parts replaced in a gear swap. Before buying, confirm the axle is an IFS front and not a solid front, and check the differential size against your vehicle.
Pinion depth on this unit is set with shims behind the inner bearing race, and the crush sleeve holds preload once the nut is tightened. Set the depth first, then carrier preload, then backlash, and confirm the tooth pattern with marking compound. Replace the seal and nut each time the pinion is removed, and check the carrier case for wear before reuse.
- Verify IFS front axle type before ordering
- Set pinion depth with shims before preload
- Tighten the pinion nut in steps while checking bearing feel
- Refill with fresh gear oil after setup
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2096 |
| UPC | 631410096125 |
| Kit type | Master kit with bearings |
| Axle location | Front |
| Axle type | GM 9.25 Inches IFS |
| Axle manufacturer | GM |
Vehicle fitment
The early-version kit fits 1988-2010 GM 9.25 inch IFS front axles only. Check your front differential size, and confirm fit for your vehicle’s year, model and trim before buying.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
On a 9.25 inch IFS differential, pinion depth is set with shims behind the inner bearing race. Finish with the crush sleeve and the marking compound pattern check to confirm the setup.
Before opening the GM 9.25 Inches IFS housing for the 35-2096 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2096 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2096 supplies installation parts for the GM 9.25 Inches IFS axle only.












