Overview
The G2 Axle and Gear 25-2031 is a minor ring and pinion installation kit for the Dana 30 TJ front axle.
Dana 30 front axles marked TJ are served by the 25-2031. G2 packs a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and marking compound for jobs that keep the existing bearings.
Within G2’s Dana 30 lineup, the 25-2031 is the minor kit for the TJ version of the front axle. It provides a proper shim kit, a pinion nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. The matching master kit, 35-2031, is for short pinion Dana 30 applications.
Key features
- Minor kit for the Dana 30 TJ axle (front)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Measuring pinion depth
Pinion depth is the first measurement in a Dana 30 gear install, and the shims in this kit are used to set it. A dial indicator and a depth gauge give the readings needed to choose the right shim stack. Work slowly, since small changes in depth move the contact pattern a great deal.
Once the depth is set, the carrier position and backlash are set next. Backlash is the small gap between the ring and pinion teeth, and it should be neither tight nor loose. After the first few trail runs, check the bolts and the pattern again, since new gears often settle a little.
- Set pinion depth before carrier position
- Check backlash with the dial indicator
- Re-check bolts after the first trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2031 |
| UPC | 631410095043 |
| Kit type | Minor kit |
| Axle location | Front |
| Axle type | Dana 30 TJ |
| Axle manufacturer | Dana |
| Manufacturer part number | G/225-2031 |
Vehicle fitment
This kit is made for the front Dana 30 TJ axle. Confirm fit for your vehicle’s axle type and year before ordering.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Dana 30 gear work is tight, so expect to measure depth with care. Use the shims, then check the contact pattern.
Before starting the 25-2031 job on the Dana 30 TJ axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2031 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2031 is a minor kit for the Dana 30 TJ axle.









