Overview
The G2 Axle and Gear 35-2035 is a master ring and pinion installation kit for the Dana 70 rear axle. Its attributes list Dana as the axle manufacturer and Dana 70 as the axle type. The kit groups the bearings, shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts and assembly compounds used when a Dana 70 ring and pinion is replaced.
Key features
- Master kit with pinion and carrier bearings
- Shim kit with crush sleeve and pinion nut
- Pinion seal for the pinion bore
- Ring gear bolts with silicone sealer, Loctite and gear marking compound
Dana 70 setup considerations
The Dana 70 is a heavy-duty rear axle, so the housing, bearing seats and pinion bore carry significant load over time. A rebuild is a good moment to inspect the carrier, the axle shafts and the pinion bearing journal for wear, since these parts are often replaced together. Note the original shim pack when disassembling, because it gives a starting point for setting pinion depth.
Carrier preload and pinion preload are set with the crush sleeve and shims, and tooth contact is checked with gear marking compound before the axle returns to service. Work slowly and recheck measurements after each change. After assembly, a short break-in period with gentle driving lets the new gears settle and gives time to check for leaks and noise.
- Inspect the carrier and bearing seats
- Keep the original shim pack for reference
- Check fluid level after the break-in period
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2035 |
| UPC | 631410095852 |
| Axle manufacturer | Dana |
| Axle type | Dana 70 |
| Axle location | Rear |
| Kit type | Master Kit With Bearings |
Vehicle fitment
No vehicle, model or year is named for this kit. It is matched to the Dana 70 rear axle, so fit depends on whether your vehicle carries that axle.
Dana 70 is an axle name, not a vehicle. Verify the axle and your vehicle’s year, model and trim before buying.
Installation notes
Dana 70 gear setup involves pinion depth and carrier preload measurements with the shims, so professional setup and a break-in check after assembly are advisable.
What’s included
- Pinion and carrier bearings
- Shim kit
- Crush sleeve
- Pinion nut
- Pinion seal
- Ring gear bolts
- Silicone sealer, Loctite and gear marking compound
Not included: the ring gear and pinion pair; the kit supports that set rather than replacing it.












