Overview
The G2 Axle and Gear 35-2016 is a master ring and pinion installation kit for GM 8.2-inch rear axles. It is a master kit with bearings, so it covers the pinion and carrier bearings, shims, seal and fasteners used when a ring and pinion is replaced. The ring and pinion gears are not included.
The kit suits mechanics replacing a worn gear set on an 8.2-inch GM rear axle, where the old bearings, seals and shims should not be reused.
Key features
- Master kit with bearings for the pinion and carrier
- Shim kit for setting pinion and carrier positions
- Replacement pinion nut, crush sleeve and pinion seal
- Ring gear bolts, Loctite, gear marking compound and silicone sealer
Replacing bearings and seals together
Pinion and carrier bearings wear with the gears, and old bearings that ran under the previous gear set rarely hold the correct preload. Replacing the bearings, seals and crush sleeve as one group keeps the setup predictable. Reusing a single old part can shift the preload enough to cause early noise.
Silicone sealer belongs on the cover and mating surfaces, not inside the gear oil path, so apply it sparingly and clean old residue first. Thread locking compound is for the bolts that call for it, and it should not be added to every fastener. Fill the axle with the correct lubricant after the break-in run.
- Clean old sealant from the cover before reassembly
- Use thread locker only on bolts that call for it
- Check fluid level after the first short drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2016 |
| UPC | 631410095616 |
| Axle type | GM 8.2 Inches |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
Vehicle fitment
Fitment is not confirmed for this kit, so the axle size is the main check. Match the axle type and ring gear size on your vehicle to the 8.2-inch GM rear axle before ordering.
A ring and pinion kit must match a specific axle size, so this kit is sized for 8.2-inch GM axles only.
Installation notes
Gear sets need professional setup, including pinion preload and gear mesh checks, and a break-in period after installation. Replace the bearings and seals in this kit together, because reusing old pinion bearings can upset preload.
What’s included
The kit covers a shim kit, replacement pinion nut, crush sleeve, pinion seal, pinion bearings, carrier bearings, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Not included: the ring and pinion gear set.










