Overview
The G2 Axle and Gear 35-2043 is a master ring and pinion installation kit for the Toyota 8 Inches front and rear axle.
Not every Toyota 8 inch differential is the same, and the 35-2043 is the version made for six cylinder and reverse-rotation third members. It contains Timken pinion bearings and races, carrier bearings and races, pinion and carrier shims, a crush sleeve, pinion nut and seal, ring gear bolts, and sealer and compounds.
Toyota built several 8 inch differentials, and G2 separates this one by engine and rotation. The 35-2043 therefore suits builders who have already confirmed they have a six cylinder or reverse-rotation third member. Its Timken bearings, races, shim sets, crush sleeve, seal and bolts cover the full gear install, in either the front or the rear.
Key features
- Master installation kit for the Toyota 8 Inches axle (front and rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Confirming third member type
Toyota 8 inch third members come in more than one design, and a six cylinder unit and a reverse-rotation unit can look close enough to confuse. Confirm the ring gear direction and the pinion orientation against the gearset you are installing before any parts are ordered or assembly starts. A mismatch shows up late, when the gear pattern is already wrong.
Shims and crush sleeves are sorted for a specific setup, so reusing them on a different third member is risky. Keep each shim pack separate and record which pack came from which position. If the cover has been off before, check that the carrier bearing caps are still paired with their housing marks.
- Compare ring gear direction before disassembly
- Record the original gear pattern with marking compound
- Keep shim packs labeled by position
- Match bearing caps to their housing marks
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2043 |
| UPC | 631410095920 |
| Kit type | Master kit with bearings |
| Axle location | Front and rear |
| Axle type | Toyota 8 Inches |
| Axle manufacturer | Toyota |
Vehicle fitment
It fits Toyota 8 inch third members from six cylinder engines and reverse-rotation units, in either front or rear position. Match it to the third member itself.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
Reverse-rotation gearsets are easy to confuse, so check the direction of your ring gear before assembly. Setup follows the usual path: shim the pinion, set the crush sleeve, adjust the carrier and read the tooth pattern.
Before opening the Toyota 8 Inches housing for the 35-2043 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2043 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2043 supplies installation parts for the Toyota 8 Inches axle only.











