Overview
The G2 Axle and Gear 25-2080A is a Dana 80 Ford Super Duty minor ring and pinion installation kit for the rear axle. It supplies the parts for a Dana 80 gear swap on the Super Duty rear differential when the bearings are being kept.
This kit suits an installer working on a newer truck. It bundles the parts a parts store rarely carries: a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Key features
- Dana 80 axle kit named for the Ford Super Duty
- Rear axle location
- Minor kit that reuses the bearings
- Shim kit for gear setup
- Pinion nut, crush sleeve and pinion seal supplied
- Bolts, silicone sealer, Loctite and marking compound
Before you buy
A minor ring and pinion kit makes sense when the carrier bearings are still in good condition and only the gear set needs replacing. Before ordering, pull the old carrier and inspect the bearing cups and rollers for pitting, heat discoloration or roughness when turned by hand. If those parts look worn, a major kit with new bearings is the safer route, even though the labor is greater.
Gear ratio and axle width should match your existing parts. Choose the ring and pinion as a matched set and buy it separately, since the gears are not part of this kit. Check pinion depth and backlash with the shim kit before final assembly, and keep a written record of each shim stack so the setup can be repeated if adjustment is needed later.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2080A |
| UPC | 631410107319 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Dana |
| Axle type | Dana 80 |
| Axle location | Rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
The kit is a universal fit for the Dana 80 rear axle, and it is chosen by that axle rather than by model years. Confirm your Super Duty’s year, model and trim before ordering.
The 25-2080A does not cover front axles or other Dana axle sizes, and no Super Duty years are stated. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting pinion depth with the shim kit and reading the pattern with marking compound are the core steps of any ring and pinion install, and a heavy truck differential like the Dana 80 benefits from an experienced installer. The kit holds no gears. The crush sleeve sets pinion bearing preload and cannot be reused, while the pinion seal holds gear oil in. New gear oil is needed once the Super Duty differential is reassembled.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: the ring and pinion and bearings.







