Overview
The G2 Axle and Gear 25-2043 is a minor ring and pinion installation kit for the Toyota 8 Inch V6 axle, with front or rear axle location. G2 intends it for a newer vehicle that has no need for new bearings during a gear change.
The 25-2043 mirrors the 4 cylinder kit in what it contains but is named for the V6 version of the Toyota 8 inch differential. Inside are a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Key features
- Toyota 8 Inch V6 axle minor installation kit
- Front or rear axle location
- Shim kit to set the gear mesh
- New pinion nut, crush sleeve and pinion seal
- Ring gear bolts included
- Silicone sealer, Loctite and marking compound
Matching the V6 axle
The V6 Toyota 8 inch axle has its own kit, so confirm the axle before ordering and again during the job. Engine version and axle markings help identify the right parts. Shims in the kit set pinion depth and backlash, and the crush sleeve sets preload, so both should be checked after assembly.
A pinion seal that is worn or damaged will let gear oil escape, and a gear swap is the right time to replace it. Keep the carrier and cover surfaces clean, and use fresh gear oil at the correct level. Watch for noise or heat after the first drives, since these can point to a setup that needs another shim adjustment.
- Replace the pinion seal during the swap
- Check the contact pattern before final assembly
- Refill with fresh gear oil at the correct level
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2043 |
| UPC | 631410095128 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Toyota |
| Axle type | Toyota 8 Inch (V6) |
| Axle location | Front or rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
It is picked by the Toyota 8 Inch V6 axle, in either the front or rear position, rather than by a single vehicle. Confirm your vehicle’s year, model and trim, and your axle, before ordering.
The 25-2043 is a different kit from the 4 cylinder Toyota 8 Inch version and from kits for other Toyota axle sizes. Confirm your vehicle’s year, model and trim, and your axle, before ordering.
Installation notes
The ring and pinion swap relies on shims for pinion depth and the crush sleeve for preload, both of which are in this kit. Gears are separate, and a trained installer will be needed to finish the setup on the V6 Toyota 8 inch axle. The pinion seal keeps gear oil inside the housing, and replacing it during a gear swap is standard practice.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: gears, bearings and carrier parts.






