Overview
The G2 Ford 9.75 Master Ring and Pinion Install Kit, part number 35-2012C, is a master installation kit for Ford 9.75-inch axles from 2007 to 2010. It covers the bearings, seals, shims and compounds used in a ring and pinion replacement, but the gear set is not part of the kit.
The kit’s contents include Timken pinion bearings, carrier bearings and races, a pinion nut and seal, a crush sleeve, shims and ring gear bolts. Beyond the contents list, no further sizes or specifications are given.
Key features
- Timken outer and inner pinion bearings with races
- Carrier bearings and races
- Crush sleeve and pinion shims
- Thread locking compound, gear marking compound and silicone sealer
Before the gear setup begins
Ring and pinion work is easier when the old parts are fully removed and the housing is clean. Wipe the carrier bore and check the pinion bearing bores for scoring before pressing in new races, since a damaged bore can throw off the setup even with fresh parts. Keep the bearing races matched to their cups so each pair stays together, and lay out the shims and crush sleeve in order so nothing is mixed up during assembly.
Once the pinion is in, gear marking compound is used to check tooth contact. Work in small adjustments and recheck after each change. If the pattern stays off after several passes, the shim stack or carrier preload is usually the place to look, and a gear shop can confirm the result.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2012C |
| UPC | 631410128901 |
| Axle type | Ford 9.75 inches |
| Noted application years | 2007-2010 |
Vehicle fitment
It is for Ford 9.75-inch axles from 2007 to 2010, which is an axle and year range rather than a specific vehicle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering. Check that your rear axle is a 9.75-inch Ford unit from the same years.
Installation notes
Ring and pinion work requires setting pinion depth and carrier preload, then checking backlash. Gear marking compound is included for the tooth pattern check, and a gear shop typically handles the setup.
What’s included
Timken pinion bearings and races, carrier bearings and races, pinion nut, pinion seal, crush sleeve, pinion shims, carrier shims, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Not included: ring and pinion gear set.





