Overview
The G2 Axle and Gear 4-YJ-488M is a 4.88 ring and pinion gear set with front and rear minor installation kits for the 1987–1995 Jeep Wrangler YJ. The kit pairs a 4.88 front gear set for the Dana 30 front axle with a 4.88 rear gear set for the Dana 35 rear axle, so both axles of the Jeep are regeared in one kit.
For the 4-YJ-488M, G2 describes its complete ring and pinion kits as including everything needed for a gear swap: front and rear gear sets plus the minor installation kits for both axles. The 4-YJ-488M gives Wrangler YJ owners a 4.88 option for changing axle gearing, and G2 says its gears are engineered for oversized tires and high performance engines.
Key features
- Complete front and rear set: 4.88 ring and pinion gear sets for both axles plus matched minor installation kits
- Built for the Dana 30 front axle and the Dana 35 rear axle
- Computer heat treated 8620 steel gears
- Manufactured to O.E. specifications.
- Double shot peened and double lapped gear sets
- Limited lifetime warranty listed by G2
Planning a gear swap
Changing both axles to the same ratio is a larger job than swapping one. Each axle needs its own pinion depth, carrier preload and backlash setup, and the front and rear must be set so the drivetrain stays matched. Tire diameter, transmission gearing and the transfer case all affect how a new ratio feels on the road and on the trail.
Before ordering, check the axle housings, the carrier bearings and the seals. Old bearings and seals are often replaced during a gear change because they are disturbed during removal. Keep track of shim stacks and marks on the carrier caps so the setup can be reproduced if a reinstallation is needed.
- Confirm the axle codes on both ends
- Replace carrier bearings and seals
- Keep shim stacks labeled during removal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-YJ-488M |
| UPC | 631410141283 |
| Product type | Ring and pinion gear sets with front and rear minor installation kits |
| Gear ratio | 4.88 |
| Vehicle named in listing | 1987–1995 Jeep Wrangler YJ |
| Front axle | Dana 30 |
| Rear axle | Dana 35 |
| Axle location | Front and rear |
| Kit type | Minor kit |
| Gear material | Computer heat treated 8620 steel |
| Finishing | Double shot peened, double lapped |
| Manufacturing | Manufactured to O.E. specs |
| Warranty | Limited lifetime warranty |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler YJ, and it applies to a Jeep with a Dana 30 front axle and a Dana 35 rear axle.
The 4-YJ-488M listing does not cover the Wrangler TJ (1997–2006), the Wrangler JK (2007–2018) and other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting the 4-YJ-488M changes the gear ratio on both axles of a Wrangler YJ, which is work for an experienced gear installer. The two minor installation kits in the 4-YJ-488M are the parts used for setting the new gears, and the same 4.88 ratio goes in both axles so the drivetrain stays matched. The 4-YJ-488M is a minor kit, and bearing sets are not among its listed contents. Plan a careful break-in for the new 4-YJ-488M gears after installation.
What’s included
- Front ring and pinion gear set, 4.88
- Rear ring and pinion gear set, 4.88
- Front minor installation kit
- Rear minor installation kit







