Overview
The G2 Axle and Gear 25-2080 is a Dana 80 minor ring and pinion installation kit for the rear axle. It supplies the setup parts for a Dana 80 differential gear change when the existing bearings are staying.
G2 builds the kit for an installer working on a newer vehicle, with the hard-to-find extras bundled together. The 25-2080 holds a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Key features
- Dana 80 rear axle installation kit
- Minor kit with no bearings listed
- Shim kit for pinion depth and mesh
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts included
- Silicone sealer, Loctite and marking compound
Gear oil and seal care
Gear oil protects the gears and bearings inside a Dana 80 housing, and seals keep it there. The pinion seal and cover gasket are the parts most likely to leak after a gear install. Replacing the pinion seal on each job protects the oil and keeps the setup clean.
After the install, check the fluid level and look for leaks at the cover, the pinion seal and the axle seals. Clean the housing first so any new drip is easy to see. Recheck the level after a short drive, since a fresh setup can settle and leave the level a little low.
- Replace the pinion seal on each job
- Clean the housing before checking for leaks
- Recheck the fluid level after a short drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2080 |
| UPC | 631410095241 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Dana |
| Axle type | Dana 80 |
| Axle location | Rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
G2 gives no vehicle list for the 25-2080 and labels it Universal Fit. It is made for the Dana 80 rear axle, so choose it by the axle under your truck.
The 25-2080 is not the kit shown as 25-2080A, which is named for the Ford Super Duty. It also does not cover Dana 70 or Dana 50 axles. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A Dana 80 gear swap relies on shims to set pinion depth and on the crush sleeve to set preload. The 25-2080 has no gears, so a professional install is the usual path, and gear oil must be refilled when the cover goes back on. Loctite secures the ring gear bolts, and the pinion seal keeps gear oil inside the heavy Dana 80 housing, so both are replaced rather than reused. Gear oil must be refilled before the truck goes back on the road.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: the gear set, carrier and bearings.






