Overview
The G2 Axle and Gear 25-2056 is a minor ring and pinion installation kit for the Toyota Tacoma 8.4-inch rear axle.
G2 designs the 25-2056 for installers working on a newer vehicle that has no need to change the bearings. The kit gathers the small parts a ring and pinion installation needs, including a shim kit, a replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, thread locking compound and gear marking compound. G2 says these are the parts that auto parts stores rarely have. The ring and pinion gear set itself is not part of the kit.
Key features
- Minor installation kit for the Toyota Tacoma 8.4-inch axle
- Pinion shims and carrier shims for setting up the gears
- Replacement pinion nut, crush sleeve and pinion seal
- Ring gear bolts and thread locking compound
- Gear marking compound for checking the contact pattern
- Silicone sealer included
- It is made for installs where the bearings do not need to be changed.
Gear setup and break-in
A minor ring and pinion kit gives an installer the small parts needed to set pinion depth, preload and backlash, but the gear set itself still has to match the axle. Tooth contact is checked with the gear marking compound, and shim changes are made until the pattern sits correctly. Patience at this stage prevents noise and early wear once the vehicle is back on the road.
After assembly, run the axle gently and recheck the bolts, the pinion nut and the fluid level. Gears need a short break-in period, so avoid heavy loads, towing or hard off-road use until the setup has settled. Keep notes of the shim thicknesses used, since those values are needed if the gears are opened again.
- Record shim thickness for future service
- Recheck pinion nut and ring gear bolts after break-in
- Use the correct fluid level for the axle
- Avoid heavy towing during the first miles
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2056 |
| UPC | 631410095227 |
| Product type | Minor ring and pinion installation kit |
| Axle | Toyota Tacoma |
| Axle location | Rear |
| Kit type | Minor kit |
| Popular axle manufacturer | Toyota |
| Universal fit for axles, matched by axle type rather than by vehicle list | Universal Fit (axle-specific, no vehicle list) |
| Contents | Pinion nut, pinion seal, crush sleeve, pinion shims, carrier shims, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
It is made for the Toyota Tacoma 8.4-inch axle, so it is matched by axle rather than by make, model or year. Match it to the 8.4-inch axle in your truck before ordering.
The kit is not for other axles such as a different Dana, Ford or GM axle size. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit is meant for gear installs where the bearings stay in place, so the axle’s existing bearings must be in good condition. The shims, crush sleeve and gear marking compound are the parts used to set pinion position, preload and the tooth contact pattern, which makes this a job for an installer with gear setup experience, followed by a careful break-in.
What’s included
- Pinion nut
- Pinion seal
- Crush sleeve
- Pinion shims
- Carrier shims
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included: ring and pinion gear set and bearings.







