Overview
The G2 Ring and Pinion Set, Dana 44 / M220 Rear 5.38 Ratio, part 2-2152-538, is a rear gear set at 5.38 for the Dana 44 and M220 rear.
G2 says its performance ring and pinion sets are made for oversized tires and high performance engines, with materials and processes that it describes as current.
Key features
- 5.38 gear ratio
- Rear axle position
- Built for oversized tires and high performance engines
Pinion depth and preload
Pinion depth and carrier preload work together. Depth sets where the pinion teeth meet the ring gear, while preload controls how tightly the bearings hold the carrier. Changing one usually affects the other, so adjustments should be made in small steps and rechecked with a contact pattern and a backlash measurement before the axle returns to service.
A rear set at this ratio gives stronger low speed pull, and that extra torque puts more stress on bearings and seals. When a new set goes in, replacing the pinion crush sleeve and checking the carrier bearing seats are common steps. Inspect the teeth for chips or pitting at each fluid change, and note any change in noise or heat as an early sign of a problem.
- Replace the crush sleeve on a pinion rebuild
- Measure backlash at several points on the ring gear
- Check carrier bearing seats for wear
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2152-538 |
| Axle location | Rear |
| Axle type | Dana 44 |
| Gear ratio | 5.38 |
| Popular axle manufacture | Dana |
Vehicle fitment
Universal fit is listed, but no vehicle is named. The set is for the rear Dana 44 or M220 at 5.38, so confirm both before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 5.38 rear set needs the pinion depth and carrier preload set correctly, so plan for a gear setup before it goes into service.
What’s included
One ring and pinion set.

















