Overview
The G2 Axle and Gear Hammer Rear Differential Cover in Advantek Gray, part number G/240-2149G, is a powder-coated nodular iron cover for M200 and Dana 35 rear axles. G2 makes the Hammer as a replacement for thin stamped covers that can bend or puncture on the trail.
A stamped cover can peel back when it slides over a rock, letting gear oil drain out. The Hammer M200 is designed to protect the gears, locker and carrier bearings from that damage. Drained gear oil is also an environmental hazard. The cast cover uses highly ductile nodular iron, with bolt-head pockets that keep the cover bolts clear of rocks.
Key features
- Highly ductile nodular iron cast cover
- Recessed pockets protect the cover bolt heads from trail damage
- Ramped profile helps the Jeep slide up and over obstacles
- Thick cross-section, from 7/16 inch up to 1 inch around the bolt ring.
- Powder-coated finish
- Listed with extra oil capacity
- Protects the gears, locker and carrier bearings from trail damage
Rear axle protection basics
The rear differential carries the locker, ring and pinion, and carrier bearings, so a cover breach affects the whole axle. Rear covers see rock strikes as the vehicle climbs, and a stamped cover can deform and open a seam that lets fluid out. A cast cover with a ramped profile reduces the chance of that damage, which helps keep the gear oil at a safe level between service intervals.
Routine checks are simple. Look for drips on the cover, wet bolt heads or a falling fluid level, and inspect the bolt ring after rock-heavy trail use. Keep the gear oil fresh at the level your axle requires, and recheck after any cover work. Small leaks found early are much easier to fix than gears damaged by running low.
- Look for drips and wet bolt heads after trail use
- Keep gear oil at the correct level
- Inspect the bolt ring after rocky runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | G/240-2149G |
| Axle type | M200 / Dana 35 Advantek |
| Axle location | Rear |
| Popular axle manufacturer | Dana |
| Material | Iron |
| Finish | Powder coated, gray |
| Thickness | 7/16 inch to 1/2 inch at the outermost surface; up to 1 inch around the bolt ring |
| Oil capacity | Extra capacity |
Vehicle fitment
No specific vehicle is covered. The cover is sold as universal fit, so the axle type decides fit rather than a vehicle. Confirm the axle is an M200 or Dana 35 rear unit, and check your year, model and trim before buying.
The G2 Hammer covers for the JL and JT are also available in bronze. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting, including the gasket and fill plug.

























