Overview
The G2 Placer Gold Dana 44 TJ front axle set, part number G/2198-2045-002, has 1.5-inch diameter, 35-spline shafts built to fit the TJ Dana 44 housing. It fits the 2003–2006 Jeep Wrangler (TJ).
The shafts use the plus-size 5-7166X series U-joints from the JK Rubicon rather than the standard joint. The axles are engineered and manufactured in the USA for strength and reliability in dedicated Jeep builds.
Key features
- 35-spline front shafts for the Dana 44 TJ housing
- 1.5-inch diameter shafts
- Plus-size 5-7166X series U-joints (JK Rubicon style)
- Engineered and manufactured in the USA.
Before you install axle shafts
Axle shafts carry torque from the differential to the hub, so their condition matters both on the trail and on pavement. Shaft length, spline count and diameter must match the axle housing and hub, and a shaft that does not seat fully can wear the splines quickly.
Plan to inspect the U-joints and retaining hardware on any new shaft set. Heavy throttle, locked differentials and tight turns put the most load on the joints, so a regular check after hard use helps catch wear early.
- Check for play at each joint after the first few drives
- Inspect the boots and seals for tears
- Use the correct retaining hardware for the joint style
- Confirm the housing and hub before pulling the old shafts
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | G/2198-2045-002 |
| Axle type | Dana 44 TJ |
| Axle location | Front |
| Spline count | 35 splines |
| Shaft diameter | 1.5 inches |
| U-joint | 5-7166X series |
| Fit type | Direct fit |
Vehicle fitment
It is a direct fit for the 2003–2006 Jeep Wrangler (TJ). Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 1.5-inch shafts are built for the TJ Dana 44 housing, so confirm the housing before fitting. The larger U-joints differ in size from the stock joints, so check the joint fit when the set is installed.








