Overview
The G2 Axle and Gear 35-2022A is a master ring and pinion installation kit with bearings for the GM 10 bolt 8.6-inch axle in the rear position.
It includes the parts needed to install a ring and pinion: Timken pinion and carrier bearings, shims, nut, seal and compounds. Some parts are hard-to-find items that auto parts stores rarely stock. It is for use in 2009 and up 8.6-inch rear axles. The ring and pinion gear set is not included.
Key features
- Master kit with bearings for the GM 10 bolt 8.6-inch axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 2009 and up 8.6-inch rear axles
Before you rebuild
A GM 10 bolt rear is commonly rebuilt when the gear teeth wear, the pinion bearing starts to feel rough, or a whine appears that changes with load. Before tearing into the housing, check the axle tag, pinion bearing feel and any metal in the fluid, since those clues show whether a full ring and pinion change is needed.
Once the old gears are out, clean the carrier and housing thoroughly and check the pinion bearing bore for wear. Good preparation makes the setup easier, and using fresh gear oil and the correct fill level after the rebuild protects the new gears during the early miles.
- Look for whine that changes with load
- Check the pinion bearing for roughness
- Clean the housing before reassembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2022A |
| UPC | 631410095692 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 10 bolt 8.6-inch |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Listing condition | For use in 2009 and up 8.6-inch rear axles |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2022A is matched by axle rather than by vehicle. It is made for the GM 10 bolt 8.6-inch axle in the rear position, for use in 2009 and up 8.6-inch rear axles. Confirm your vehicle’s year, model and trim before ordering.
It is not for other axle designs or sizes, so confirm the axle type before buying.
Installation notes
A master kit such as the 35-2022A rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2022A are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2022A: ring and pinion gear set.













