Overview
The G2 Axle and Gear 35-2025 is a master ring and pinion installation kit for the AMC 20 front and rear axle.
The 35-2025 is the master installation kit for the AMC 20 axle. Its list covers a pinion nut and seal, Timken pinion bearings with races, pinion and carrier shims, carrier bearings with races, ring gear bolts, thread locker, marking compound and silicone sealer, with no crush sleeve named.
The AMC 20 is listed by G2 for both front and rear positions, so the same master kit serves either end. It supplies Timken pinion bearings and races, carrier bearings and races, pinion and carrier shims, a pinion nut and seal, ring gear bolts, thread locker, marking compound and silicone sealer. As noted, a crush sleeve is not on the list.
Key features
- Master installation kit for the AMC 20 axle (front and rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Pinion spacer and preload
Pinion preload is set by the spacer and the nut, and it controls how much the pinion bearings resist turning. Too little preload lets the pinion move under load, while too much causes heat and early bearing failure. Setting it correctly is the step most likely to be rushed.
Because a spacer is needed for AMC 20 installs, identify the type your axle uses before the old pinion comes out. A solid spacer and a crush sleeve work differently, and the measurement method changes with each. Keep the old spacer for reference during reassembly.
Carrier bearings and the carrier shims should be reset along with the pinion, since backlash depends on both. Clean the housing thoroughly, lubricate the bearings with gear oil, and recheck the contact pattern after the first drive.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2025 |
| UPC | 631410095739 |
| Kit type | Master kit with bearings |
| Axle location | Front and rear |
| Axle type | AMC 20 |
| Axle manufacturer | AMC |
Vehicle fitment
The kit is for AMC 20 axles in both front and rear positions. Identify the axle by its housing before ordering.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
Check what pinion spacer your AMC 20 needs, since a crush sleeve is not on this kit’s contents list. Use the supplied shims for depth and the marking compound to read the pattern.
Before opening the AMC 20 housing for the 35-2025 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2025 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2025 supplies installation parts for the AMC 20 axle only.













