Overview
The G2 Axle and Gear 25-2010 is a minor ring and pinion installation kit for the GM 14 Bolt 9.5 Inches rear axle.
Rear GM 14 bolt axles with a 9.5 inch ring gear are served by the 25-2010. The contents are a shim kit, nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and marking compound; bearings are not part of the kit.
The 9.5 inch 14 bolt is a lighter-duty GM rear axle, and G2’s 25-2010 is its minor kit. The contents are practical and specific: a proper shim kit, a pinion nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. A master kit for this axle, the 35-2010, adds the bearings.
Key features
- Minor kit for the GM 14 Bolt 9.5 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Before you tear down
A minor kit is meant for a rebuild that keeps the original bearings, so the first step is checking them. Spin each bearing by hand and look for roughness, pitting, or heat marks on the rollers. Worn bearings will affect the new gear pattern, and it is far easier to replace them now than to reset the setup later.
Plan for a careful, unhurried job. Clean the carrier and housing, measure the old pinion depth where possible, and keep the shims sorted by size so they can go back in the same order if the pattern needs a check. A torque wrench and a dial indicator are the usual minimum tools.
- Clean the housing and carrier before measuring
- Keep the old shims sorted by thickness
- Replace the pinion nut and seal every time
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2010 |
| UPC | 631410094848 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | GM 14 Bolt 9.5 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2010 |
Vehicle fitment
It fits the rear GM 14 bolt 9.5 inch axle. Identify the axle by its size before ordering.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Mark the old gear contact before teardown if you can, then compare to the new pattern. Shims set depth; the crush sleeve sets pinion preload.
Before starting the 25-2010 job on the GM 14 Bolt 9.5 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2010 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2010 is a minor kit for the GM 14 Bolt 9.5 Inches axle.







