Overview
The G2 Axle and Gear 35-2021 is a master ring and pinion installation kit with bearings for the GM 8.5-inch (10 bolt) axle, for the rear axle position.
The 35-2021 includes the parts needed to install a ring and pinion, with pinion and carrier bearings along with the shims, nut, seal and compounds. Some of its parts are hard-to-find items that auto parts stores rarely stock. It is for use in 81-98 8.5-inch rear axles only. The ring and pinion gear set is not included.
Key features
- Master kit with bearings for the GM 8.5-inch (10 bolt) axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 81-98 8.5-inch rear axles only
Rear axle rebuild notes
A rear axle rebuild starts with the housing. Look for cracks, a worn carrier bore and bearing seats that spin in place before any new parts go in. Any of those issues changes the job, so inspect the housing first and plan the bearing and shim work around what you find.
The 8.5-inch design rewards careful setup. Because the crush sleeve and pinion nut set preload in one pass, they are meant to be replaced once a rebuild starts. Gear marking compound shows whether the tooth contact sits where it should, and small shim changes move that pattern in predictable ways.
- Inspect bearing bores and races for spinning or scoring
- Use fresh gear marking compound for each pattern check
- Keep the pinion seal surface clean and free of nicks
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2021 |
| UPC | 631410095654 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 8.5-inch (10 bolt) |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Listing condition | For use in 81-98 8.5-inch rear axles only |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2021 is identified by axle rather than by vehicle: it is made for the GM 8.5-inch (10 bolt) axle in the rear position, for 81-98 8.5-inch rear axles only. Confirm fit for your vehicle’s year, model and trim before ordering.
The 35-2021 is made only for the GM 8.5-inch (10 bolt) axle and is not designed for other axle designs or sizes. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A master kit such as the 35-2021 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2021 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2021: ring and pinion gear set.













