Overview
The G2 Axle and Gear 35-2023 is a master ring and pinion installation kit with bearings for the GM 14 bolt 10.5-inch axle, used in the rear axle position.
The 35-2023 follows G2’s master kit approach: it includes the parts needed to install a ring and pinion, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. Some of these parts are hard to find and rarely stocked by auto parts stores. It is for use in 1973-1987 small bearing rear axles. The ring and pinion gear set itself is not included.
Key features
- Master kit with bearings for the GM 14 bolt 10.5-inch axle
- Timken outer and inner pinion bearings and races
- Timken pinion pilot bearing included
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 1973-1987 small bearing rear axles
Choosing a master kit
A master ring and pinion kit replaces the parts that wear as a set, so the gears and bearings are usually rebuilt together rather than mixing old bearings with new gears. When gathering parts, compare the kit’s contents with the job in front of you. Pinion depth, carrier preload and the tooth pattern all depend on the shims and crush sleeve, so review those before opening the housing.
Older small bearing axles often show wear in the carrier bearing bores and pinion bearing cups, so inspect those surfaces before fitting new races. Keep the old gear pattern photos and measurements for reference during setup. Expect the first hours of driving to be a break-in period, and recheck pinion nut torque and ring gear bolt torque after the first few trail runs.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2023 |
| UPC | 631410095708 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 14 bolt 10.5-inch |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Listing condition | For use in 1973-1987 small bearing rear axles |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, Timken pinion pilot bearing, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2023 is identified by axle rather than by vehicle: it is made for the GM 14 bolt 10.5-inch axle in the rear position, for use in 1973-1987 small bearing rear axles. Fitment is set by the axle itself, so match the axle to your vehicle before buying.
The 35-2023 is made for this axle design and size only. Check that your vehicle’s year, model and trim match the axle before ordering.
Installation notes
A master kit such as the 35-2023 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2023 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Timken pinion pilot bearing
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2023: ring and pinion gear set.











