Overview
The G2 Axle and Gear 25-2015 is a minor ring and pinion installation kit for the GM 10 Bolt 7.5 Inches rear axle.
GM’s 10 bolt 7.5 inch rear is covered by the 25-2015. The kit holds a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, and no bearings.
This minor kit covers the GM 10 bolt 7.5 inch rear axle, a smaller GM design. G2’s 25-2015 offers a proper shim kit, a pinion nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, all matched to a gear install that keeps the original bearings in the housing.
Key features
- Minor kit for the GM 10 Bolt 7.5 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Telling GM and Ford axles apart
Ford and GM rear axles of similar size can look alike from the outside, so identification comes before buying any gear kit. The axle tag, the housing shape and the ring gear bolt pattern are the usual checks. Once the axle is identified, the kit can be matched to the correct carrier.
A 7.5 inch GM rear with the original bearings in place is a common refresh job. Note the stock shim stack, the carrier cap markings and the pattern on the old gears before taking anything apart. Those notes make it easier to see whether the new pattern needs more or less shim.
Replacing the pinion seal, crush sleeve and pinion nut each time the pinion is removed keeps the setup clean. Torque the nut in steps and check preload as you go.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2015 |
| UPC | 631410094893 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | GM 10 Bolt 7.5 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2015 |
Vehicle fitment
It is a minor kit for the rear GM 10 bolt 7.5 inch axle. Confirm your vehicle’s axle type and year before ordering.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Check the axle tag or housing shape to separate the GM unit from the Ford one. After assembly, the marking compound pattern tells you whether more shimming is needed.
Before starting the 25-2015 job on the GM 10 Bolt 7.5 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2015 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2015 is a minor kit for the GM 10 Bolt 7.5 Inches axle.








