Overview
The G2 Axle and Gear 35-2027A is a master ring and pinion installation kit for the Chrysler 8-inch axle, built for the Dakota IFS from 00 up. The kit groups a shim kit, replacement pinion nut, crush sleeve, pinion seal, pinion and carrier bearings, ring gear bolts, silicone sealer, Loctite and gear marking compound into one package.
Fitment is labeled universal, yet this kit is built around the Chrysler 8-inch axle, so match the axle before ordering.
Key features
- Master kit with pinion and carrier bearings
- Shim kit for pinion and carrier setup
- Replacement pinion nut, crush sleeve and pinion seal
- Ring gear bolts with Loctite and silicone sealer
- Gear marking compound for tooth contact checks
Choosing and preparing a rebuild
A master kit covers the small parts of a ring and pinion change, but the gear set itself is a separate purchase. Before starting, pull the old carrier and inspect the pinion bearing bore and carrier housing for scoring, since a worn bore can throw off pinion depth even with new shims. Mark the old shims and keep them grouped by position so you have a reference while setting up the new gears. Clean every mating surface and remove old sealer completely before applying fresh sealer.
Plan the rebuild around the steps that cannot be skipped. Pinion depth and carrier preload are set with measurements and gear marking compound, and new gears should be broken in gradually after assembly. Check the lubricant level once the axle is back together, and recheck the ring gear bolts after the first few drives.
- Keep fresh sealer and locking compound on hand
- Replace the pinion seal any time the nut is removed
- Recheck ring gear bolt tightness after early drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2027A |
| UPC | 631410095746 |
| Axle manufacturer | Chrysler |
| Axle type | Chrysler 8 Inches |
| Kit type | Master Kit With Bearings |
Vehicle fitment
The kit is built for the Dakota IFS from 00 up. Confirm the axle size and that your vehicle’s year, model and trim match before ordering.
Confirm the axle size and that your vehicle’s year, model and trim match before ordering. The universal label does not confirm a specific Dakota year or trim.
Installation notes
Ring gear bolts, Loctite and silicone sealer each have their own use and cure requirements, so follow the cure guidance printed for each one. Pinion depth and carrier preload need measuring equipment, so professional setup is advised.
What’s included
- Pinion and carrier bearings with races
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer, Loctite and gear marking compound
Not included: the ring gear and pinion pair that the kit is fitted around.











