Overview
The G2 Axle and Gear 35-2028 is a master ring and pinion installation kit with bearings for the Chrysler 9.25-inch rear axle.
The 35-2028 follows G2’s master kit approach: it includes the parts needed to properly install a ring and pinion, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. G2 says some of the parts in the 35-2028 are hard to find items that auto parts stores rarely stock. The 35-2028 does not contain the ring and pinion gear set itself.
Key features
- Master kit with bearings for the Chrysler 9.25-inch axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
Setting pinion depth and preload
Pinion depth, carrier preload and backlash all depend on the shims and the crush sleeve, so the setup is more than a bolt-on job. Shims adjust how far the pinion sits in the carrier, and the crush sleeve sets the preload on the pinion bearings as the nut is tightened. Work through the setup in small steps and recheck the measurements after each change.
Gear marking compound shows the tooth contact pattern, and a centered pattern on both drive and coast sides is the goal before the carrier is closed. Thread locking compound and silicone sealer should be used only where they are needed, and the ring gear bolts should be tightened in a crisscross pattern. Break the new gears in gently after the axle is back together.
- Use new crush sleeves and nuts rather than reusing old ones
- Clean the housing and carrier surfaces before assembly
- Check tooth contact before final assembly
- Refill with the correct gear oil after the break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2028 |
| UPC | 631410095760 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | Chrysler 9.25-inch |
| Axle location | Rear |
| Popular axle manufacturer | Chrysler |
| Kit type | Master kit with bearings |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2028 is made for the Chrysler 9.25-inch axle in the rear position. Fit is by axle rather than by vehicle, so check the axle size and design against your vehicle’s rear end before ordering.
The kit is for the Chrysler 9.25-inch axle only and does not suit other axle designs or sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A master kit such as the 35-2028 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2028 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2028: ring and pinion gear set.













