Overview
The G2 Axle and Gear 25-2064A is a minor ring and pinion install kit for Toyota 10.5-inch axles. It supplies the pinion nut, pinion seal, crush sleeve, shims, ring gear bolts and setup compounds used when a ring and pinion set is installed.
Shoppers searching for a Toyota 10.5 minor install kit will find seals, shims and compounds here, but the contents do not include ring or pinion gears.
Break-in after installation
A newly installed ring and pinion needs a break-in period so the tooth surfaces can settle. Drive gently for the first stretch, avoid heavy towing or hard launches, and check for unusual whine, clunk or heat from the housing. Small changes in noise often point to setup issues rather than a bad part.
Gear oil should be changed once the break-in is complete, since fine metal particles from the new surfaces collect in the oil during the first miles. Recheck the pinion nut and ring gear bolts after the first drives, and keep an eye on the seals for leaks. Replacing the carrier bearings and pinion bearings alongside the gears helps the setup hold its adjustment. Keep the original shims and markings for reference if the axle is serviced again. Note any changes in noise and address them early.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2064A |
| UPC | 631410129274 |
| Axle | Toyota 10.5-inch |
| Kit type | Minor ring and pinion install kit |
Vehicle fitment
Fitment for this Toyota 10.5-inch kit is best verified against the axle and ring gear before ordering.
Installation notes
Ring and pinion setup controls gear mesh, pinion depth and bearing preload, so it is usually done by a professional using the gear marking compound in the kit. Plan for a break-in period once the set is installed.
What’s included
Pinion nut, pinion seal, crush sleeve, pinion shims, carrier shims, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Not included: ring gear and pinion gear set.








