Overview
The G2 Axle and Gear 35-2095 is a master ring and pinion installation kit for the GM 8.25 Inches IFS front axle.
The 35-2095 is for the GM 8.25 inch independent front axle. Within the box are Timken pinion and carrier bearings with races, pinion and carrier shims, a crush sleeve, nut and seal, ring gear bolts, and sealer plus compounds for a complete differential install.
G2’s 35-2095 is for the GM 8.25 inch independent front differential. The master kit renews Timken pinion and carrier bearings with races, and supplies pinion and carrier shims, a crush sleeve, a nut and seal, ring gear bolts, thread locker, marking compound and silicone sealer. G2 restricts it to IFS front axles, so rear housings of similar size are not covered.
Key features
- Master installation kit for the GM 8.25 Inches IFS axle (front)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Front differential work on GM IFS
An independent front differential is more involved than a solid front axle. The housing sits on the frame, so the unit is removed or well supported, and the axle shafts and steering components need attention during the job. Plan the work with clean space and room to lift the housing.
Gear setup follows the same routine as other ring and pinion jobs: pinion depth with shims, carrier preload, backlash, then the marking compound pattern check. Replace the pinion seal and nut every time the pinion is pulled. Inspect the axle shaft seals and carrier bearings before reassembly, since a leaking seal can let a gear set run low on oil.
- Support or remove the IFS unit safely
- Replace pinion seal and nut each time
- Check axle shaft seals while the housing is open
- Refill with fresh gear oil once the pattern is confirmed
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2095 |
| UPC | 631410096118 |
| Kit type | Master kit with bearings |
| Axle location | Front |
| Axle type | GM 8.25 Inches IFS |
| Axle manufacturer | GM |
Vehicle fitment
The kit fits GM 8.25 inch IFS front axles only, and it is not made for solid rear axles. Confirm fit for your vehicle’s year, model and trim before buying.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
An IFS front differential sits in a housing bolted to the frame, so the work is done with the unit out or well supported. Shim for depth, set the crush sleeve and check the contact pattern with marking compound.
Before opening the GM 8.25 Inches IFS housing for the 35-2095 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2095 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2095 supplies installation parts for the GM 8.25 Inches IFS axle only.











