Overview
The G2 Axle and Gear 25-2013 is a minor ring and pinion installation kit for the Ford 8.8 Inches rear axle.
The 25-2013 is the minor kit for rear Ford 8.8 inch axles. Its contents: shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. No bearings are in the box.
A Ford 8.8 inch rear with healthy bearings is the intended use of the 25-2013. G2 puts the proper shim kit, pinion nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound together. The master version, 35-2013, covers 2008 and earlier axles and adds Timken bearings and races for builds that need them.
Key features
- Minor kit for the Ford 8.8 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Reusing old parts safely
A minor ring and pinion kit assumes the existing bearings are still in good shape. Before reassembly, turn each bearing by hand and feel for roughness, play or binding. Look for pitting, heat discoloration or flat spots on the rollers. Any bearing that fails these checks should be replaced, because a new pinion and ring gear wear quickly on a worn carrier or pinion bearing. Clean the carrier thoroughly and remove all old gear oil before setting up the new gears.
Shim changes are the most important part of the job. Work in small steps, check the tooth contact pattern after each change, and keep a record of which shim pack went where. Use a dial indicator to measure backlash and pinion depth, and read the pattern with the gear marking compound. Replace the crush sleeve and pinion nut rather than reusing them, since both are designed for one use. Use fresh thread locker on the ring gear bolts and torque them evenly.
- Turn each bearing by hand before reassembly
- Replace the crush sleeve and pinion nut
- Log every shim change and the resulting pattern
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2013 |
| UPC | 631410094879 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | Ford 8.8 Inches |
| Axle manufacturer | Ford |
| Manufacturer part number | G/225-2013 |
Vehicle fitment
It fits the rear Ford 8.8 inch axle. Confirm fit for your vehicle’s year, model and trim before ordering. The master version, 35-2013, adds bearings for 2008 and earlier axles.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Plan shim changes in small steps and recheck the pattern after each. Reused bearings should spin smoothly and show no pitting.
Before starting the 25-2013 job on the Ford 8.8 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2013 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2013 is a minor kit for the Ford 8.8 Inches axle.





