Overview
The G2 Chrysler 8.25-inch Minor Ring and Pinion Install Kit, part number 25-2029B, is a minor installation kit for 8.25-inch Chrysler axles covering years 05-10. It contains installation hardware rather than gears.
This kit contains installation hardware, not gears. Complete gear sets for oversized tires and high performance engines are sold separately, so check the contents against your gear order before installing.
Key features
- Pinion nut and pinion seal
- Crush sleeve for pinion preload
- Pinion shims and carrier shims
- Ring gear bolts with thread locking compound
- Gear marking compound and silicone sealer
Backlash and contact checks
Backlash is the small gap between ring and pinion teeth, and it needs to sit within the range the gear set calls for. Too little causes heat and noise, and too much causes clunking and early wear. Gear marking compound shows the tooth pattern so the setup can be judged before the axle is closed up.
Hardware quality matters on a minor kit. Thread locking compound and silicone sealer belong on specific fasteners and gasket faces, so apply them only where the procedure directs. Tighten ring gear bolts in a crisscross pattern to keep the ring gear flat against the carrier.
- Check backlash at several points on the ring gear
- Follow the tightening order for ring gear bolts
- Do not reuse the pinion nut or seal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2029B |
| UPC | 631410126709 |
| Axle type | Chrysler 8.25 inches |
| Years in title | 05-10 |
| Kit type | Minor installation kit |
Vehicle fitment
It is for Chrysler 8.25-inch axles, years 05-10. Confirm fit for your model and trim before ordering.
This kit is for Chrysler 8.25-inch axles, years 05-10. Confirm fit for your model and trim before ordering, and check the axle and ring gear size against your housing.
Installation notes
Ring and pinion setup uses gear marking compound to check the tooth contact pattern and backlash, and professional gear setup is typical. Silicone sealer and thread locking compound are included, so apply them only where the instructions call for them.
What’s included
Pinion nut, pinion seal, crush sleeve, pinion shims, carrier shims, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Not included: ring gear and pinion gear set.






