Overview
The G2 Axle and Gear 30-9056 is a front wheel bearing kit for the Toyota Tacoma and Tundra with a Toyota 8.4 inch series axle. It covers one side and is a direct fit for the 2001–2004 Tacoma and the 2000–2005 Tundra.
The kit includes the primary items needed to replace wheel bearings, with Timken tapered bearings and seals. Confirm your truck’s year against the years in Vehicle fitment below before ordering.
Key features
- Front wheel bearing kit for the Toyota 8.4 inch series axle
- Covers one side
- Direct fit for the 2001–2004 Tacoma and 2000–2005 Tundra
- Includes the primary items for a wheel bearing replacement
- Timken tapered bearings and seals.
Front hub service tips
Front hubs on four-wheel-drive trucks see steering loads and driveline forces in addition to the weight of the truck. Keep the hub and spindle surfaces clean and free of rust before fitting new bearings, since a rough surface can turn a small fault into early noise and wear.
Setting front bearing preload takes patience. Tighten to the procedure, back off, and retighten so the hub turns smoothly with little play. Check the brake rotor for runout and the caliper for seizing, since both can make a new bearing feel rough once the truck is driven.
- Clean the spindle before fitting bearings
- Set preload with the hub turning smoothly
- Check rotor runout before reassembly
- Replace the seal along with the bearings
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 30-9056 |
| UPC | 631410116663 |
| Product type | Wheel bearing kit |
| Position | Front |
| Axle | Toyota 8.4 inch series |
| Quantity | 1 side |
| Bearing type | Timken tapered bearings (G2 states its kits use them) |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the 30-9056 covers the 2001–2004 Toyota Tacoma and the 2000–2005 Toyota Tundra. It is a front axle kit.
The 30-9056 does not cover Tacoma years before 2001 or later than 2004, nor Tundra years outside the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Front wheel bearing work on a Tacoma or Tundra means removing the hub assembly, seating the new bearings and seals, and setting preload. Hardware is not included with this kit, and the kit serves one side only, so a second kit is needed for the other wheel. Both trucks use this one part number. Replacing the seals with the bearings keeps dirt and grease out of the new parts.
What’s included
- Wheel bearings and seals for one side, per G2’s description of its wheel bearing kits
Not included: a kit for the opposite side, and any hardware not described by G2.







