Overview
The G2 Axle and Gear 35-2030 is a master ring and pinion installation kit for Chrysler 7.25-inch axles. The axle location attribute lists both front and rear positions. The kit bundles pinion and carrier bearings, a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound for a ring and pinion replacement.
Key features
- Master kit with pinion and carrier bearings
- Shim kit, crush sleeve and replacement pinion nut
- Pinion seal with ring gear bolts
- Silicone sealer, Loctite and gear marking compound
Front and rear setup differences
Front and rear 7.25-inch Chrysler positions can use different pinion angles, housings and setup procedures, so the position should be confirmed before any gear work starts. A front axle often has steering and driveline components that change access, while a rear axle may be easier to measure with the housing in place. Either way, mark the carrier caps and shim positions as you remove them.
Gear setup relies on measurements taken with the carrier and pinion seated, along with tooth contact checks using gear marking compound. Plan for the shim changes that may be needed, and replace the pinion nut and crush sleeve rather than reusing them. A second check after a short test drive helps confirm the setting holds under load.
- Confirm axle position before buying tools or parts
- Keep carrier caps marked in their original positions
- Use new bolts and seals during assembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2030 |
| UPC | 631410095784 |
| Axle manufacturer | Chrysler |
| Axle type | Chrysler 7.25 Inches |
| Axle location | Front and Rear |
| Kit type | Master Kit With Bearings |
Vehicle fitment
No vehicle, model or year is named for this kit. It is matched by axle manufacturer, Chrysler, and axle type, 7.25 inches, with front and rear locations.
Confirm the Chrysler model and year that use this 7.25-inch axle, and confirm the axle position, before ordering.
Installation notes
Setting carrier preload and pinion depth requires measuring equipment and gear-setting experience, and front and rear positions use different setups. Confirm the position before starting.
What’s included
- Pinion and carrier bearings
- Shim kit
- Crush sleeve
- Replacement pinion nut
- Pinion seal
- Ring gear bolts
- Silicone sealer, Loctite and gear marking compound
Not included: a ring gear and pinion set, which must be matched to this kit and obtained separately.












