Overview
The G2 Dana 35, Ford 7.5 and GM 7.5 rear wheel bearing kit, number 30-9008, provides the parts for one side of a rear axle. It fits Dana 35, Ford 7.5 inch and GM 7.5 inch rear axles.
The fitment grid shows the Ford axle as 8 inches, while the title says 7.5 inch. Measure the Ford axle before installing the kit.
Key features
- All parts for one side of the axle
- Rear position
- It is a direct fit for the Dana 35, Ford 7.5 inch and GM 7.5 inch rear axle types.
- Covers Dana 35, Ford and GM 10 bolt axles
Choosing and fitting a bearing kit
Rear wheel bearings carry the wheel and pass its load into the axle housing, so wear shows up as play at the hub, a noise that changes with speed or turns, or heat after a drive. A one-side kit covers only the bearing side of the job. Plan to inspect the axle shaft, seal and retainer at the same time, since those parts are often disturbed during the same work.
Axle identification matters more than model year for these kits. Measure the housing and bearing bore before buying, and compare them with the axle installed in your vehicle. When the old set comes out, look at the races and rollers for pitting or blue discoloration. Pack the new bearings with fresh grease and keep everything clean during the press work.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Kit number | 30-9008 |
| UPC | 631410095470 |
| Position | Rear |
| Axle types | Dana 35; Ford 8 inches per grid (7.5 inch per title); GM 10 bolt 7.5 inch |
| Coverage | One side |
Vehicle fitment
The kit is matched by axle type, not by vehicle year or model. Confirm the Ford axle size, since the title and grid differ, before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lift and support the vehicle on stands before pulling the axle, and wear eye protection when pressing bearings.
What’s included
Parts for one side only. Not included: the second side’s parts and the axle shaft.
