Overview
The Omix-ADA 16706.03 is a front hub inner bearing for the 1977–1986 Jeep CJ5, CJ7 and Scrambler.
The inner hub bearing sits closest to the vehicle and, with the outer bearing, supports the hub on the spindle. A worn inner bearing often shows up as play or noise at the wheel.
It is a direct OE replacement built to the original specifications, for the front position.
A tapered roller bearing like this one is normally replaced together with its cup, along with the outer bearing and seal, when the front hub is serviced. It is the inner bearing for the front position on the classic CJ models. Compare it with the old bearing before fitting.
Key features
- Front hub inner bearing
- Front position
- Direct OE replacement, built to the original specifications
- Built to the original specifications
- Limited five year warranty from the manufacturer
Inner bearing wear and setup
The inner bearing carries the load that pushes the hub inward, and it takes the most stress when the vehicle corners or carries weight. Wear usually appears as a grinding or rumbling noise that changes with speed, or as looseness at the wheel when it is rocked by hand. Heat at the hub after a drive can also point to a bearing that is set too tight or damaged.
Because the inner and outer bearings share the load, replacing one while the other is worn leaves the hub prone to early failure. Pack the bearing with a suitable high-temperature grease, seat the cup fully, and set preload using the method in your service information. Recheck the hub after a short drive.
- Inspect the spindle for scoring
- Replace the seal along with the bearing
- Use clean grease and clean hands
- Check the hub nut after the first drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16706.03 |
| UPC | 804314035143 |
| Part type | Front hub inner bearing |
| Position | Front |
| Warranty | Limited five year warranty. |
Vehicle fitment
It fits the following Jeep models:
- 1977–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1977–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
It fits the 1977-1983 CJ5, 1977-1986 CJ7 and 1981-1985 Scrambler. Wrangler and Cherokee applications need separate confirmation. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
One inner hub bearing, part number 16706.03.
Not included: the outer bearing, seals and hub hardware.









