Overview
The G2 35-2012B is a master ring and pinion install kit for Ford 9.75-inch axles, built for use with the factory ring and pinion. It is made for Ford 9.75-inch axles from 2011-2016 that keep the OEM ring and pinion.
The kit includes Timken outer and inner pinion bearings and races, carrier bearings and races, a pinion nut and pinion seal, a crush sleeve, and pinion and carrier shims for setup. Because the kit is written for factory gears, the gear set itself is not part of it.
Key features
- Timken outer and inner pinion bearings and races
- Carrier bearings and races
- Pinion nut, pinion seal and crush sleeve
- Pinion shims and carrier shims
- Ring gear bolts, thread locking compound, gear marking compound and silicone sealer
Confirming factory gears
A master kit built for factory gears only works if the existing ring and pinion is a matched OEM set. Gears that have been swapped or re-cut lose the match, and the new bearings will not set up correctly. Inspect the tooth faces and the pinion shaft for wear before reusing the kit.
Carrier bearings and races are where most of the setup work happens, because preload and backlash are chosen there. Expect to repeat the shim check a couple of times before the pattern looks right. Record each shim stack so the final setup can be reproduced if the carrier is opened again.
- Verify the gear set is the original OEM pair
- Log final shim thickness for each side
- Break in the new bearings with light load first
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2012B |
| UPC | 631410126563 |
| Axle type | Ford 9.75-inch |
| Kit type | Master kit for use with factory ring and pinion |
| Stated compatibility | Ford 9.75-inch, 2011-2016, OEM ring and pinion |
| Bearings | Timken pinion and carrier |
Vehicle fitment
Fit is set by axle family and years only: Ford 9.75-inch axles from 2011-2016 that keep the OEM ring and pinion. No vehicle model or chassis code is part of the fit.
Confirm your vehicle’s year, model and trim before ordering. Confirm that your axle keeps the OEM ring and pinion before installing this kit.
Installation notes
Setting pinion depth, carrier preload and backlash with the factory gears is the core job, and a tooth contact check with gear marking compound confirms the result. Professional setup is recommended.
What’s included
Timken outer and inner pinion bearings and races, carrier bearings and races, pinion nut, pinion seal, crush sleeve, pinion shims, carrier shims, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Not included: The factory ring and pinion gear set is not included; the kit is written for use with it.









