Overview
The G2 Axle and Gear 25-2023A is a minor ring and pinion installation kit for the GM 14 Bolt 10.5 Inches rear axle.
Later 14 bolt axles with the big 10.5 inch ring gear use the 25-2023A. G2 provides a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, leaving out bearings.
For 1988 and later builds of the GM 14 bolt 10.5 inch axle, G2 offers the 25-2023A as its minor kit. It collects the shim kit, nut, crush sleeve, seal, bolts, silicone sealer, Loctite and marking compound. A master version with bearings and a pilot bearing, the 35-2023A, is the alternative when the bearings also need replacing.
Key features
- Minor kit for the GM 14 Bolt 10.5 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Reusing bearings safely
Bearings kept in place need their preload measured, not guessed. Turn the pinion with an inch-pound or torque wrench and compare the reading with the old setting, since worn bearings change the figure. A reading that drifts high or low means the crush sleeve and shim stack need another look before the carrier goes back in.
Check the carrier and housing for wear as well. Bearing bores, carrier journals and the pinion head should be clean and free of galling. Damage there can throw off a new gear setup even when every kit part is correct.
- Measure drag torque before and after the shim change
- Keep each bearing with its original race
- Inspect the pinion seal surface for wear
- Verify backlash with a dial indicator
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2023A |
| UPC | 631410094961 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | GM 14 Bolt 10.5 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2023A |
Vehicle fitment
It fits the rear GM 14 bolt 10.5 inch axle built from 1988 and up. Earlier 1973 to 1987 builds use the 25-2023 instead.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Reusing bearings on a 10.5 inch gear set means measuring the preload you actually get, so a torque wrench or inch-pound reading is worth taking. Then confirm the tooth pattern.
Before starting the 25-2023A job on the GM 14 Bolt 10.5 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2023A are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2023A is a minor kit for the GM 14 Bolt 10.5 Inches axle.







