Overview
The G2 Axle and Gear 35-2032 is a master ring and pinion installation kit for the Dana 30 Standard front and rear axle.
The standard Dana 30 gets its own master kit in the 35-2032. Its contents are a pinion nut and seal, Timken inner and outer pinion bearings with races, pinion and carrier shims, carrier bearings with races, ring gear bolts, thread locker, marking compound and silicone sealer, with no crush sleeve on the list.
This kit is the master set for the standard Dana 30, used in both front and rear positions, and it is separate from the short pinion kit. It includes Timken pinion bearings, carrier bearings and races, shim sets, a nut, a seal, bolts, thread locker, marking compound and silicone sealer. A crush sleeve is not included, so check what the pinion preload method needs on your housing before starting.
Key features
- Master installation kit for the Dana 30 Standard axle (front and rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
- Includes thread Locking Compound
Pinion preload without a crush sleeve
Without a crush sleeve in the kit, the pinion preload has to be set with a collapsible spacer or solid spacer chosen for the housing. Preload is the grip the pinion bearings have on the shaft, and it must be right before the gears are run. Set the depth shims first, then bring the preload up in small steps while turning the pinion, checking the reading as you go.
The marking compound pattern is the final check. Standard Dana 30 housings are often rebuilt for trail use, so inspect the carrier bores and bearing seats for wear before pressing in the new races.
- Choose the spacer type to match your pinion setup
- Tighten the pinion nut in small steps while checking preload
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2032 |
| UPC | 631410095807 |
| Kit type | Master kit with bearings |
| Axle location | Front and rear |
| Axle type | Dana 30 Standard |
| Axle manufacturer | Dana |
Vehicle fitment
It fits standard Dana 30 axles in both front and rear positions. The short pinion version uses kit 35-2031. Confirm that your housing is a standard Dana 30 before ordering.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
With no crush sleeve in the list, plan to reuse or source a collapsible spacer or solid spacer based on your pinion setup. Depth shims and the marking compound still do the main work in getting the pattern right.
Before opening the Dana 30 Standard housing for the 35-2032 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2032 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2032 supplies installation parts for the Dana 30 Standard axle only.











