Overview
The G2 Axle and Gear 4-JKRUB-456M is a complete 4.56 ring and pinion kit with minor installation kits for the Dana 44 front and rear axles of Rubicon Jeep Wrangler JK models from 2007 on.
The 4.56 ratio is the mildest of G2’s three JK Rubicon gearing choices here. It gives front and rear Dana 44 gear sets with a minor installation kit for each axle. G2 builds them from computer heat treated 8620 steel to O.E. specs, shot peened twice and lapped twice. Its application line reads: 07-Current Wrangler JK, 2 and 4 door.
The 4.56 ratio is the closest to stock for owners with moderately larger tires on a Rubicon JK, and it keeps engine speed lower on the highway than deeper ratios do. The kit is built for the Rubicon’s Dana 44 front and rear axles, with a minor installation kit for each axle to complete a gear swap.
Key features
- Front and rear 4.56 gear sets
- Dana 44 front and Dana 44 rear
- Rubicon models, 2 and 4 door
- Matched minor installation kits
- Manufactured to O.E. specs
- Limited lifetime warranty.
Rubicon gearing considerations
Rubicon JKs run Dana 44 axles front and rear, so any ratio change affects both ends at once. A move to a 4.56 ratio is a middle path for owners who run larger tires and still want reasonable highway manners. The right choice depends on tire diameter, transmission gearing and how much time is spent off road versus on pavement.
Gear swaps are usually paired with related work. Shops often replace the carrier bearings, check the axle seals, and confirm the differential fluid is correct before the vehicle returns to service. Look at tire size and driveline angles too, since larger tires change how the drivetrain behaves at highway speed.
- Confirm the tire diameter before choosing a ratio
- Replace carrier bearings and seals during the swap
- Check driveline angles after a lift or tire change
- Note engine speed and noise during the first few trips
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-JKRUB-456M |
| UPC | 631410141139 |
| Part type | Ring and pinion gear kit with minor installation kits |
| Gear ratio | 4.56 |
| Axles | Dana 44 front, Dana 44 rear |
| Models | Rubicon, 2 and 4 door |
| Steel | Computer heat treated 8620 |
| Finishing | Double shot peened, double lapped |
| Warranty | Limited lifetime |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler JK Rubicon models, 2 and 4 door.
Non-Rubicon JKs, the TJ and the JL are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gears are matched front to rear, so both axles are done together. Professional setup of pinion depth and backlash is the usual route, followed by a break-in.
What’s included
- Front 4.56 ring and pinion set
- Rear 4.56 ring and pinion set
- Front and rear matched minor installation kits
Not included: Bearings and other parts beyond the minor kits, so check the full parts list before starting.






