Overview
The G2 Axle and Gear 35-2019 is a master ring and pinion installation kit with bearings for the GM 12 bolt car, 8.875-inch axle, in the rear axle position.
The 35-2019 follows G2’s master kit approach: it includes the parts needed to properly install a ring and pinion, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. G2 says some of the parts in the 35-2019 are hard to find items that auto parts stores rarely stock. The 35-2019 does not contain the ring and pinion gear set itself.
Key features
- Master kit with bearings for the GM 12 bolt car, 8.875-inch axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
Car versus truck setups
The car version of a GM 12 bolt is built for a lighter axle role than the truck version, so matching the axle to the setup matters. A master kit gives the installer the bearings and shims for the rear axle, but the gear set still has to suit the axle ratio. Confirm the axle type by checking the existing housing before you start.
Good preparation saves time. Clean the housing thoroughly and check the pinion bearing bore for wear. Keep the shims sorted by size, and do not reuse the crush sleeve or pinion nut. Gear marking compound should be used on both drive and coast sides so the pattern is read accurately before the cover goes on.
- Measure the housing before ordering
- Clean the bearing bores before assembly
- Check the cover gasket before reassembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2019 |
| UPC | 631410095647 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 12 bolt car, 8.875-inch |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
This kit is matched by axle rather than vehicle. It is made for the GM 12 bolt car, 8.875-inch axle in the rear position. Check the axle type against your vehicle before choosing it.
It will not suit other axle designs or sizes. Match the axle design and size before ordering.
Installation notes
A master kit such as the 35-2019 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2019 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2019: ring and pinion gear set.











