Overview
The Crown Automotive 5066025AB is an outer axle shaft boot kit for the Dana 30 front axle, in the front left outer position. The boot protects the axle joint and holds grease in place.
The kit includes grease and straps. It is a direct fit for the Dana 30 front axle position.
Key features
- Outer axle shaft boot design
- Front left outer position
- Includes grease and straps
- Dana 30 front axle
- Direct fit listed
Boot replacement basics
A boot protects the joint from dirt and water and keeps the grease in place. Once it tears, grit can enter the joint and wear it faster, and grease can slowly leak out. Boot kits are usually replaced when the old boot is cracked, torn or hardened, not only when it fails completely.
Clean the joint thoroughly before packing it with fresh grease, and remove old grease from the housing. Check the axle shaft for damage, since a bent or scored shaft will wear a new boot quickly. Fit the straps and clamps snugly so the boot seats evenly on both ends.
After installation, check for grease that appears at the seams during the first drives, and look at the boot again after rough trails. Keep a spare set of clamps on hand if your axle layout requires them.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5066025AB |
| UPC | 848399033885 |
| Axle | Dana 30 front axle |
| Position | Front left outer |
| Included | Grease, straps |
| Fitment | Direct fit |
Vehicle fitment
It is made for the front left outer position of the Dana 30 front axle. Confirm fit for your vehicle’s year, model and trim before you buy, and confirm the side you need.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Boot replacement usually means removing the axle shaft and cleaning the joint before packing it with the supplied grease. Support the vehicle securely while the axle is out.
What’s included
Boot kit with grease and straps.
Not included: Have clamps and axle hardware ready, since some axle setups need them.








