Overview
The Bilstein 33-170794 is a 5100 Series steering damper, also called a steering stabilizer, with 12.7mm eye mounts at both ends. Its gas pressure monotube design eliminates cavitation and foaming, which helps control vibration in the steering components of late model trucks and Jeeps.
It offers precise steering damping with digressive valving and a zinc finish protected by the Triple C process. The 46mm smooth body is a non-coilover design, and it is an O.E. replacement for 36mm and 46mm models that reduces wear on steering components.
Key features
- Gas pressure monotube design that eliminates cavitation and foaming
- Precise steering damping that reduces steering component vibration
- Digressive valving for driver comfort and confidence
- Bilstein Triple C process zinc finish for corrosion resistance
- Reduces wear and tear on steering components
- O.E. replacement for 36mm and 46mm models.
- A boot is included.
Checking the damper before install
A steering damper sits between the steering linkage and the frame, controlling how quickly the wheels can move sideways. When it is worn or the gas charge is lost, the wheel can shake or wander at speed, and the vibration can be felt through the steering wheel. Inspect the eye mounts and bushings for cracking, since a loose mount can allow the damper to bind.
Check the boot, the shaft and the seals for damage before fitting. A torn boot lets grit reach the shaft and speeds up wear, so replace a damaged boot promptly. Look for oil at the body, which can point to a seal failure that needs attention before the damper goes back into service.
Mounting brackets and hardware are a separate purchase here, so plan for them before the install. Match the eye mounts to the bracket holes, and tighten all fasteners once everything is aligned. Recheck the damper after the first few drives, since new mounts can settle slightly.
- Inspect eye mounts for cracks
- Check boot and shaft for damage
- Look for oil leaks at seals
- Plan brackets before installing
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-170794 |
| UPC | 651860649344 |
| Series | 5100 Series |
| Type | Stabilizer only |
| Collapsed length | 14.72 in. |
| Extended length | 23.64 in. |
| Travel length | 8.92 in. |
| Lower mount | Eye, 12.7mm |
| Upper mount | Eye, 12.7mm |
| Shaft diameter | 11mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Monotube |
| Reservoir | No |
| Finish | Zinc plated |
| Single / dual | Single |
| Boot included | Yes |
| Brackets included | No |
Vehicle fitment
It is made for late model trucks and Jeeps. Make sure your year, model and trim suit this damper before buying.
Compare the 12.7mm eye mounts with your vehicle’s stabilizer mounting points before ordering.
Installation notes
Brackets are not included, so confirm your mounting hardware works with your setup before starting. Steering components are safety-critical, so have the installation checked by a qualified shop.
What’s included
A boot is included. The damper is a single unit and is stabilizer only.
Not included: Brackets are not included.









