Overview
The Baer Brakes 6920354 is a right-side, two-piece vented replacement brake rotor with an 11 inch outside diameter and a 1.02 inch nominal thickness. It is a slotted, drilled and zinc-plated cast iron rotor used front and rear on Baer Extreme+ systems, and it is also used in certain Baer Pro Plus and other Baer brake systems.
Made for one side of the vehicle, the right-side 6920354 is sold separately from its left-side partner. It is a performance-grade replacement rotor for owners running a Baer brake setup. Confirm your Baer system, hub and bolt pattern before choosing it, since this is not a generic fit.
Key features
- Purpose-built castings made from premium materials
- Curved vane design that Baer says helps cooling
- Engineered for rotor stability and resistance to distortion
- Dynamically balanced for vibration-free performance
- Slotted, drilled and zinc-plated surface finish
- Directional brake surface made for the right side
- Vented cast iron construction in a two-piece design
Checking the right side
A directional rotor only works as designed when it is mounted on the side it was made for. Before the wheel goes back on, look at the friction surface and the vane orientation, and make sure the rotor sits flat against the hub face with no rust or debris between them. Clean the hub and mounting surface with a wire brush, then check that the rotor turns without rubbing the caliper bracket or dust shield.
Two-piece rotors have a separate hat and friction ring, so inspect the fasteners that join them and the hat’s mounting face as well. Runout and thickness variation can cause brake pulsation, so a technician will often measure both after installation. Replacing pads at the same time and bedding them in gives the new surface a consistent contact pattern.
- Verify the directional marking before mounting
- Clean hub and mounting faces to bare metal
- Check caliper clearance over the new thickness
- Tighten bolts to the vehicle’s specified value
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920354 |
| UPC | 844165012399 |
| Axle side | Right |
| Construction | Two piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Material | Cast iron |
| Surface type | Slotted, drilled and zinc plated |
| Outside diameter | 11 in |
| Nominal thickness | 1.02 in |
| Mounting bolt holes | 10 |
| Mounting bolt hole circle diameter | 6.4 in |
| Grade type | Performance |
| ABS tone ring included | No |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | CN |
Vehicle fitment
Confirm your vehicle’s year, model and trim before ordering. Compare the 11 inch diameter, 1.02 inch thickness and 6.4 inch bolt circle against your current rotor, since this is not a generic fit.
Installation notes
Rotors are directional, so confirm you have the right-side part and that the directional surface is oriented correctly when mounted. Rotor hardware can be reused up to 3 times before replacing, so inspect bolts and studs at every brake service. A qualified brake technician should check the installation and test the brakes before driving.
What’s included
One right-side rotor, sold individually.
Not included: ABS tone ring (the part details state it is not included) and the left-side rotor, which is a separate part.













