Overview
The Baer Brakes 6801162 is a rear caliper rebuild kit for caliper types 6S, 6R and Xtr. It services one caliper and provides pressure and weather seals, a stainless steel pad anti-rattle clip, crush washers and a bleeder dust cap. The O-rings are sized for pistons of 1.1875, 1.125 and 1.000 inch diameter.
Pad abutments come separately and are not part of this kit, so plan for them during the rebuild. Confirm the caliper type and piston sizes against your existing hardware before ordering.
Key features
- EPDM rubber pressure and weather seals
- Stainless steel brake pad anti-rattle clip
- Crush washers and bleeder dust cap included
- Services one rear caliper per kit
- Square-rim O-rings for 1.1875, 1.125 and 1.000 inch pistons
- Covers caliper types 6S, 6R and Xtr.
Rear caliper inspection
Rear caliper types vary in how the pads are held, so the pad hardware matters as much as the seals. Anti-rattle clips keep the pad from moving in its bracket and reduce noise over bumps. They are small parts, but a missing or bent clip can change how the pad sits and cause a rattle that is hard to trace.
When rebuilding, inspect the pad abutments and bracket surfaces for grooves, cracks, or heavy corrosion, and replace anything worn. Clean the bracket where the clip sits and confirm that the pad slides freely. Keep the new seals clean and lubricated with brake fluid before fitting, and bleed the system once everything is reassembled.
- Look for fluid seepage at the piston
- Check that the pad slides without binding
- Replace worn or corroded abutments
- Reuse a serviceable bleeder screw
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801162 |
| UPC | 90127959503 |
| Position | Rear |
| Caliper type | 6S, 6R, Xtr |
| O-ring inside diameter | 1.1875, 1.000 and 1.125 inch |
| O-ring material | EPDM rubber |
| O-ring rim shape | Square |
| Seal type | O-ring |
| Emission code | 6 |
| Pad abutments included | No |
| Pad anti-rattle clip included | Yes |
| Pressure seals included | Yes |
| Weather seals included | Yes |
| Bleeder screw dust cap included | Yes |
| Bleeder screw included | No |
| Package type | Kit |
| Country of origin | USA |
Vehicle fitment
It is identified by caliper types 6S, 6R and Xtr and the rear position. Confirm the caliper type on your existing hardware before choosing it.
Calipers outside the 6S, 6R and Xtr types are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pad abutments come separately, so decide whether your setup needs them before reassembly. Disassemble the caliper fully and clean the bores before fitting the new seals. Each of the three O-ring sizes goes in its matching bore, so confirm the piston size first. Caliper rebuilds are safety work: if hydraulic brakes are new to you, a qualified shop should perform the job.
What’s included
The kit includes one stainless steel pad anti-rattle clip, pressure and weather seals, crush washers and a bleeder dust cap, all for one rear caliper.
Not included: Pad abutments and the bleeder screw. Brake pads and the caliper body are not part of this kit.













