Overview
The Power Stop KC1943A is a 1-Click caliper kit for the front axle with drilled and slotted vented rotors, red calipers and Z23 Evolution Sport pads.
Kits in this line combine the three parts that make up a front brake corner. Power Stop lists cross-drilled and slotted rotors, red powder coated calipers and Z23 carbon fiber and ceramic pads as what a kit contains.
The calipers are remanufactured, lubricated and pressure tested at Power Stop’s facility in Chicago, IL. The pads are designed to bite firmly while running quiet and producing less dust. The kit is a direct fit for the front axle, with vented rotors and a natural finish.
A caliper kit replaces the whole front brake corner, so the old calipers, rotors and pads all come off together. That is more work than a pad swap, but it removes the chance of reusing a worn caliper with fresh pads. Use the part number KC1943A when checking fit, and match the year, model and trim against your vehicle before buying. The front position is clear, and rear kits use other part numbers.
Key features
- Front 1-Click caliper kit
- Drilled and slotted rotors
- Red powder coated calipers
- Z23 Evolution Sport pads
- Vented rotors
- Natural color
Before you replace a corner
When a front brake job covers the calipers as well as the rotors and pads, the work is usually done in one session. Start by jacking the vehicle securely and removing the wheels, then inspect the brake lines and hoses before anything is disconnected. Hoses that are cracked or swollen should be replaced at the same time, since a caliper kit already opens the hydraulic circuit.
Choosing between a caliper kit and a pad-and-rotor set comes down to the condition of the existing calipers. Calipers that stick, leak fluid, or pull the car to one side under braking are good reasons to replace the whole corner. Pad wear alone does not always call for new calipers.
- Look for fluid leaks around the piston seals
- Check that the slide pins move freely
- Bed in the new pads gradually after installation
Specifications
| Brand | Power Stop |
|---|---|
| Part number | KC1943A |
| UPC | 792088800367 |
| Part type | Caliper kit with rotors and pads |
| Position | Front |
| Rotor type | Vented |
| Caliper type | Aftermarket |
| Color | Natural |
| Pads | Z23 Evolution Sport Carbon Fiber and Ceramic |
| Fit type | Direct fit |
Vehicle fitment
No vehicles are named for KC1943A. All that is stated is that it fits the front axle as a direct fit.
Without a vehicle list, compare the part number against Power Stop’s application data rather than guessing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan on replacing rotors, calipers and pads as one job. Since calipers are involved, bleed the front brakes and test the pedal before driving.
What’s included
- Cross-drilled and slotted rotors
- Red powder coated calipers
- Z23 Evolution Sport pads







