Overview
The Alloy USA 17109 is a GM 12 bolt rear axle shaft with 30 splines and a 31.281 inch overall length, for the driver or passenger side. It fits 1970-1981 GM 1500 2WD models, including the Chevrolet C10 and Blazer and GMC Jimmy.
The shaft is heat treated and induction hardened and made from 1541H or 4140 steel. Its 30 splines must match the differential or carrier gear set. Measure the axle housing before ordering to confirm the match.
Key features
- Replacement shaft for the GM 12 bolt rear axle
- 30 spline with a 31.281 inch overall length
- Fits the driver or passenger side
- Fits 70-81 GM 1500 2WD trucks.
- Alloy USA says its shafts are heat treated and induction hardened
- Bearings, seals and studs are not included
Checking the axle before installing
Before this 30 spline shaft goes in, measure the axle housing and the old shaft, since the overall length and spline count have to match the existing setup. A shaft that is too short or too long will not sit correctly in the housing. Confirm the housing width before ordering a replacement, because the width determines whether the shaft will seat.
Shafts on older trucks often have seen long service, so the bearings, seals and studs may be worn. Replacing those parts during the job prevents repeat work. Clean the axle tube and check the brake components while the wheel is off. A shaft that rattles or clunks after installation should be checked again before the truck is driven hard.
- Measure the old shaft’s overall length
- Check spline count against the carrier
- Replace seals and bearings with the shaft
- Inspect brake components while the wheel is off
Specifications
The 17109 is a replacement axle shaft for the GM 12 bolt rear axle, with 30 splines and an overall length of 31.281 inches.
| Brand | Alloy USA |
|---|---|
| Part number | 17109 |
| UPC | 80177304431 |
| Part type | Replacement axle shaft |
| Axle | GM 12 bolt rear |
| Axle shaft location | Driver or passenger side |
| Spline | 30 spline |
| Overall length | 31.281 inches |
| Manufacturer part number | ALY17109 |
| Application stated | 70-81 GM 1500 2WD |
Vehicle fitment
The manufacturer fitment list for the 17109 names: 1970–1974 Chevrolet Blazer; 1970–1981 Chevrolet C10; 1970–1981 Chevrolet C10 Suburban; 1975–1981 Chevrolet K5 Blazer; 1975–1978 GMC C15 Suburban; 1970–1974 GMC C15/C1500 (Pickup Base); 1970–1974 GMC C15/C1500 Suburban; 1979–1981 GMC C1500; 1979–1981 GMC C1500 Suburban; 1970–1981 GMC Jimmy.
It is for 70-81 GM 1500 2WD applications.
Measure the shaft you are replacing and compare it with the 17109 listing for spline count, length and side.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
None of the bearings, seals or studs are included with the 17109, so check the condition of the old ones during the swap. Confirm the axle size before ordering.
What’s included
One axle shaft.
Not included: Bearings, Seals, Studs.







