Overview
The Alloy USA 74356-1X is a 27-spline Dana 35 C-clip rear right axle shaft. It fits 1992–2005 Jeep Cherokee XJ, Grand Cherokee ZJ and WJ, and Wrangler YJ, TJ and LJ models. It is built from 4340 chromoly that is heat-treated, tempered and induction hardened, and it is designed to be up to 40% stronger than stock 1040 axles. The splines are formed rather than cut, and each shaft is CNC machined, magnaflux inspected for cracks and finished in black anodize.
The shaft uses a C-clip design for a Dana 35 rear axle and is marked for use with ABS. It is the rear right position, and the shaft location is driver or passenger. Each shaft is covered by a ten-year warranty.
Key features
- Dana 35 C-clip rear axle shaft with 27 splines
- 4340 chromoly, heat-treated, tempered and induction hardened
- Designed to be up to 40% stronger than stock 1040 axles
- CNC machined and magnaflux inspected for cracks
- Black anodized finish
- Marked for use with ABS
- Covered by Alloy USA’s ten-year warranty, per the maker
Before fitting a C-clip shaft
C-clip axles hold each shaft with a clip inside the differential, so the shaft’s end and the clip groove have to match. Before fitting, inspect the old clip, the groove and the differential side gear splines for wear. A worn groove or a missing clip can let the shaft walk out under load, which is far more serious on a trail than in a driveway. Take your time with the clip, since it is easy to damage.
ABS-equipped axles use a tone ring that the wheel sensor reads, so check that the axle carries the matching ring before fitting a shaft marked for ABS. Replacing the axle seal and bearing at the same time keeps the job to one teardown. Clean the bearing bore and check the axle tube for cracks while the housing is open.
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 74356-1X |
| UPC | 804314212469 |
| Axle manufacturer | Dana |
| Shaft location | Driver Or Passenger |
| Axle position | Rear |
| Axle type | Dana 35 |
| Position | Rear Right |
| Spline count | 27 Splines |
| Material | 4340 chromoly |
| Axle design | C-clip |
| Finish | Black anodized |
| ABS | For use with ABS |
Vehicle fitment
It fits three Jeep families, by model and trim:
- 1992–2001 Jeep Cherokee (XJ) (Base, Briarwood, Classic, Country, Laredo, Limited, SE, Sport)
- 1999–2005 Jeep Grand Cherokee (WJ) (Laredo, Limited, Overland, Special Edition, Sport)
- 1993–1998 Jeep Grand Cherokee (ZJ) (5.9 Limited, Base, Laredo, Limited, Orvis, SE, TSi)
- 2004–2005 Jeep Wrangler (LJ) (Unlimited)
- 1997–2005 Jeep Wrangler (TJ) (SE, Sahara, Sport, X)
- 1993–1995 Jeep Wrangler (YJ) (Base, Renegade, Rio Grande, SE, Sahara)
Cherokee XJ, Grand Cherokee ZJ and WJ, and Wrangler YJ, TJ and LJ are the years shown above. JK and JL Wranglers, Comanches and Jeeps with a different rear axle are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a C-clip shaft, so it belongs in a Dana 35 axle that retains its shafts with C-clips, and the ABS note means your axle should carry the matching tone ring.







