Overview
The Alloy USA 10662 is a Dana 60 front inner axle shaft with 35 splines for use with a 5-806X U-joint. It fits 1979-1993 Dodge Dana 60 front passenger side and 1986-1997 Ford Dana 60 front driver side applications.
Alloy USA claims its heat-treated, induction-hardened shafts have twice the tensile strength of a stock shaft and are up to 35% stronger. The steel is 1541H or 4140 depending on the application. Spline count matters: the 35 splines on the 10662 have to agree with the gear set inside the axle.
Key features
- Inner axle shaft for the Dana 60 front axle
- 35 spline
- For use with a 5-806X U-joint
- Fits 79-93 Dodge Dana 60 front passenger side
- Fits 86-97 Ford Dana 60 front driver side
- Alloy USA says its shafts are heat treated and induction hardened
- Passenger side inner, also known as front left inner
- U-joint: For use with 5-806X U-joint
Choosing the right side
An inner axle shaft connects the differential side gear to the U-joint, so it carries drive torque between the gears and the driveline. Because it sits inside the axle housing, replacing it usually means draining the differential and removing the axle assembly. Check the gear set and spline count before buying, since the shaft must match the gears inside the housing.
Identify the side first by checking which side of the truck the axle is on, then compare the spline count and U-joint size of the old inner shaft. Inner shafts are often replaced with the differential seals and axle seal, so inspecting those while the housing is open saves a later repair. Look for play at the joint, oil leaks at the seal, or grinding from the gears as signs of wear.
- Measure the old shaft’s spline count before ordering
- Inspect the U-joint for wear
- Replace the axle seal when the shaft is out
- Check the differential fluid for metal debris
Specifications
The 10662 is a replacement inner axle shaft for the Dana 60 front axle, with 35 splines. Every figure in the table below is the manufacturer value for the 10662.
| Brand | Alloy USA |
|---|---|
| Part number | 10662 |
| Part type | Replacement inner axle shaft |
| Axle | Dana 60 front |
| Axle shaft location | Passenger side inner, also known as front left inner |
| Spline | 35 spline |
| U-joint | For use with 5-806X U-joint |
| Application stated | 79-93 Dodge Dana 60 front passenger side; 86-97 Ford Dana 60 front driver side |
Vehicle fitment
The manufacturer fitment list for the 10662 names: 1994–2002 Dodge Ram 2500; 1994–2002 Dodge Ram 3500; 1987–1993 Dodge W250; 1972–1980 Dodge W300; 1981–1993 Dodge W350; 2000–2004 Ford F-250 Super Duty.
It is for the 79-93 Dodge Dana 60 front passenger side and the 86-97 Ford Dana 60 front driver side.
Check the old shaft’s spline count and length against the 10662 specifications before you start the job.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It fits Dodge applications on the passenger side and Ford applications on the driver side. Confirm which side you need before installation.







