Overview
The Alloy USA 21102 is a one-piece AMC Model 20 rear axle shaft with 29 splines for the driver side. It fits 1976-1983 Jeep CJ Wide Trac models, 1982-1986 CJ7 and 1982-1985 Scrambler.
Alloy USA makes its axle shafts from 1541H or 4140 steel, depending on the application, and each shaft is heat treated and induction hardened. The 29-spline shaft engages a matching 29-spline differential or carrier. It replaces the old shaft as a single unit for the driver side. Measure the old shaft’s overall length to confirm the match before installation.
Key features
- One-piece replacement shaft for the AMC Model 20 rear axle
- 29 spline
- Driver side
- Fits 76-83 Jeep CJ Wide Trac
- Alloy USA says its shafts are heat treated and induction hardened
- Bearings, seals and studs are not included
- Axle: AMC 20 rear
- Axle shaft location: driver side, left position
- Manufacturer part number: ALY21102
Shaft replacement checks
A replacement axle shaft has to match the axle housing, the differential spline and the wheel side it serves. Before fitting, look at the old shaft’s splines, bearing surface and flange for wear or galling. Check the seal surface for grooves, since a rough spot can leak lubricant past a new seal. Make sure the bearing type matches the housing and that the new shaft seats fully.
AMC 20 axles of this era are often serviced as a set, so check the opposite side as well. Worn shafts can wobble, and a loose or sheared shaft can drop a wheel. Keep the wheel bearing grease fresh and tighten the retaining hardware to the correct specification for your vehicle.
- Check splines and flange surfaces
- Inspect the seal area for grooves
- Confirm the bearing type fits the housing
Specifications
The 21102 is a one-piece replacement axle shaft for the AMC 20 rear axle, with 29 splines. Every figure in the table below is the manufacturer value for the 21102.
| Brand | Alloy USA |
|---|---|
| Part number | 21102 |
| UPC | 70000531015 |
| Part type | One-piece replacement axle shaft |
| Axle | AMC 20 rear |
| Axle shaft location | Driver side, left position |
| Spline | 29 spline |
| Manufacturer part number | ALY21102 |
| Application stated | 76-83 Jeep CJ Wide Trac |
Vehicle fitment
The manufacturer fitment list for the 21102 names: 1982–1986 Jeep CJ7; 1982–1985 Jeep Scrambler.
It fits 76-83 Jeep CJ Wide Trac models.
Before ordering the 21102, compare its spline count, side and overall length with the shaft being replaced.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Before installing the 21102, set aside bearings, seals and studs, since none come with the shaft.
What’s included
One axle shaft.
Not included: Bearings, Seals, Studs.









