Overview
The Alloy USA 21115C is a chromoly semi-floating rear axle shaft for the Dana 60. It has 35 splines, is 29.25 inches long, and has a dual bolt pattern.
It is sold individually. No vehicle, year or model is given for it.
Key features
- 35 spline chromoly shaft
- Semi-floating rear design
- Dual bolt pattern
- Sold individually
Semi-floating shaft basics
On a semi-floating axle, the shaft carries the wheel load as well as the drive torque, so the wheel bearing and axle flange work together with the shaft. This design is common on heavier rear axles and is often chosen for off-road use where the shafts see high loads. Because the shaft is part of the wheel support, any wear in the bearing or flange affects the shaft as well.
Chromoly shafts are often selected for added strength, but the spline fit and housing condition still decide how well they perform. Check the shaft ends for rounding or pitting, and inspect the axle seal for leaks that could contaminate the bearings. When one side is damaged, replacing shafts in matched sets helps keep both rear wheels behaving alike.
- Confirm the housing and spline fit
- Inspect shaft ends and flanges for wear
- Replace both sides when one is damaged
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 21115C |
| Position | Rear |
| Axle type | Dana 60 |
| Material | Chromoly |
| Floating style | Semi-floating |
| Splines | 35 |
| Length | 29.25 inches |
| Bolt pattern | Dual |
| Quantity | Sold individually |
Vehicle fitment
This shaft is designed for the Dana 60 rear axle type, so it is matched to that housing rather than to a named vehicle.
Check the housing against the 35 spline count and 29.25 inch length before ordering. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because this is a semi-floating shaft, match the Dana 60 housing and the 35 spline count before fitting, and fit one shaft per side.






